Upload
others
View
10
Download
0
Embed Size (px)
Citation preview
AMK Compressor Rebuild Kit
Please note that this is not an easy repair like our Hitachi and Wabco repair kits. The AMK
compressor has been built very specifically
risk of the piston cracking in this repair aswell as damage to the electrical components. Great care
must be taken when taking apart this compressor.
are prepared to replace the entire unit incase you damage it.
1. Begin with removing the 8 torx bolts that hole the electrical cover and dryer unit
7 bolts can be seen below.
The dryer unit will pull up but depending on how seized the electrical cover is with
need tapping off.
Please note that this is not an easy repair like our Hitachi and Wabco repair kits. The AMK
specifically so that it is very difficult for an owner to repair.
risk of the piston cracking in this repair aswell as damage to the electrical components. Great care
must be taken when taking apart this compressor. Please do not repair this compressor unless you
are prepared to replace the entire unit incase you damage it.
torx bolts that hole the electrical cover and dryer unit
will pull up but depending on how seized the electrical cover is with
Please note that this is not an easy repair like our Hitachi and Wabco repair kits. The AMK
for an owner to repair. There is
risk of the piston cracking in this repair aswell as damage to the electrical components. Great care
Please do not repair this compressor unless you
torx bolts that hole the electrical cover and dryer unit and piston cover.
will pull up but depending on how seized the electrical cover is with corrosion it may
Remove the allen bolt so that you have access to the other side of the electrical
pressed out.
Remove the allen bolt so that you have access to the other side of the electrical unit so that it can be unit so that it can be
To push the electrical unit out will require either a press
you let this soak in PB Blaster or Plus Gas overni
piston. It's best to soak it, hammer it and then follow up with a press.
Once the unit presses out you will be able to pull out the piston. Proceed to remove the
on the piston cap, these can sometimes snap so we have included a replacement cap and screws just
incase! Replace all 4 seals on the seal. The flat
your finger to gain it's shape and fit them on, they are very flexible.
To push the electrical unit out will require either a press or some hammering. We highly recommend
you let this soak in PB Blaster or Plus Gas overnight as sometimes the bearing can seize onto the
piston. It's best to soak it, hammer it and then follow up with a press.
you will be able to pull out the piston. Proceed to remove the
on the piston cap, these can sometimes snap so we have included a replacement cap and screws just
4 seals on the seal. The flat seals arrive flat so you will need to wrap them around
gain it's shape and fit them on, they are very flexible.
ring. We highly recommend
s sometimes the bearing can seize onto the
you will be able to pull out the piston. Proceed to remove the 3 torx bolts
on the piston cap, these can sometimes snap so we have included a replacement cap and screws just
you will need to wrap them around
Push the piston back in, when it gets to the top seal
the seal so it is ready to have the electrical unit pressed back in.
Once the unit is pressed put the cap back on,, watch out for the bushes, they will need pushing back
inwards as you push the cover on.
when it gets to the top seal you can slap it in to get it past the ridge. Line up
the seal so it is ready to have the electrical unit pressed back in.
is pressed put the cap back on,, watch out for the bushes, they will need pushing back
inwards as you push the cover on.
you can slap it in to get it past the ridge. Line up
is pressed put the cap back on,, watch out for the bushes, they will need pushing back
Replace the final o-rings and fit the compressor back together and the repair has been completed.