Aquatrex* Large Diameter Filter

Figure 1: Aquatrex Filters

Description and Use Aquatrex* Filters combine innovative depth filter technology, quality cost effectiveness to provide excellent filtration value in residential and light commercial applications.

Expanding its Product Line GE Water & Process Technologies is continuing to expand its product line to meet current market demand with the introduction of our new large diameter (LD) filter. Manufactured with our world-renowned Meltblown Microfibers Technology, the engineered gradient density feature of this car-tridge provides exceptional dirt-holding capacity and unequaled life compared to our equivalent rated standard filters. The LD filter, with its three to eight times greater dirt-holding capacity and life, will reduce change-out frequency, adding more value in applications where high capacity and infrequent change-outs are desired.

This product is ideally suited to be used in AMETEK's Big Blue and Keystone's Blue Giant housing units. (Blue Blue is a trademark of US Filter/Siemens. Blue Giant is a trademark of Metpro Keystone Filter Divi-sion.) The LD filter has pure FDA compliant polypro-pylene construction, and is manufactured using ISO 9001 certified process.

Typical Applications • Whole House Filtration • Spa and Pool Filtration • Restaurant and Food Service • Water Filtration

General Properties

High Dirt-Holding Capacity • Unique dual-graded density design of the ex-

tended media captures particles throughout en-tire filter depth

• High dirt-holding capacity means longer life and fewer change-outs, which translates into money saved

• Precision final filter results in consistent high-performance filtration

• Large media area allows for high flow rates (Maximum recommended flow rate is 10 gpm for 10, 20, 30, and 50 microns, 5 gpm for 1, and 5 microns per 10-inch length. Change-outs rec-ommended at 25 psid)

Lenntechinfo@lenntech.com Tel. +31-152-610-900www.lenntech.com Fax. +31-152-616-289

Lenntech

info@lenntech.com Tel. +31-152-610-900www.lenntech.com Fax. +31-152-616-289

Page 2 FS1099EN

Table 1: High Flow Rate at Low Pressure Drop1

1 Data based on 10” length filter with clean water

Pure Polypropylene Construction • Thermally-bonded microfibers for positive dirt

retention • High-purity polypropylene media has no wetting

agents, solvents, antistatic agents or binders • Wide chemical compatibility • Temperatures to 150ºF (65°C) • Meets the requirements of the FDA Title 21 of

The Code of Federal Regulations 174.5 and relevant subparts of 177.

Proven Manufacturing Process • Automated, consistent manufacturing process

ensures reliable performance and repeatable results

• Large diameter filter manufacturing is ISO 9001 certified assuring continuous product quality

Ordering Information When Ordering GE LD filter cartridges please select a micron rating and a length (Table 2). Example: LD 10-9.875

Table 2: Ordering Information

Material and FDA Compliance

Aquatrex large diameter cartridge filters are made from thermally-welded blown microfibers of poly-propylene. GE certifies that the resin used for manu-facturing the filter media of this product meets the requirements of the Food and Drug Administration (FDA) Title 21 of the Code of Federal Regulations (CFR) 174.5 and relevant subparts of 177.

Important Notice To User:

The following is made in lieu of all other warranties expressed or implied. Manufacturer’s and Seller’s only obligation shall be to issue credit against the purchase or replacement of the product proved to be defective in material or workmanship. Neither Manufacturer nor Seller shall be liable for any injury, loss or damage, direct or indirect, special or consequential, arising out of the use of, misuse, or the inability to use such product. The information contained herein is based on technical data and tests which we believe to be reliable and is intended for use by persons having technical skill at their discretion and risk. Since conditions of use are outside GE’s control, we can assume no liability whatsoever for results obtained or damages incurred through the application of the data pre-sented. This information is not intended as a license to operate under, or a recommendation to infringe upon, any patent of or others covering any material or use. The foregoing may not be altered except by a written agreement signed by officers of the Manufacturer.

Lenntechinfo@lenntech.com Tel. +31-152-610-900www.lenntech.com Fax. +31-152-616-289

Large Diameter ‐series cartridge filters are all the models that are potentially possible in all variations.

e that not all models are actually produced or on stock and some model numbers and names have become obsolete.

ss this should help as cross reference table chart for Cuno filters nomenclature.

Aquatrex LD WP series Hurricane S1 series ECP series PP series Hytrex Purtrex LD01‐10 LD‐01‐10 WP1BB97P 1238935 WP.Zs 20‐19 1/2 HC‐40‐0.35 S1‐20BB ECP5‐BB PP30‐BB GX10‐9‐3/4 GX‐10‐9‐3/4 PX10‐9‐3/4

LD01‐20 LD‐01‐20 WP5BB97P 1238934 WP.Zs 10‐19 1/2 HC‐40‐035 S1‐20‐BB ECP5‐20BB PP‐30‐BB GX05‐9‐3/4 GX‐05‐9‐3/4 PX05‐9‐3/4

LD05‐10 LD‐05‐10 WP10BB97P 1238933 WP.Zs 05‐19 1/2 HC‐40‐1 S120BB ECP5BB PP30BB GX01‐9‐3/4 GX‐01‐9‐3/4 PX01‐9‐3/4

LD05‐20 LD‐05‐20 WP25BB97P 1238932 WP.Zs 01‐19 1/2 HC‐40‐5 S120‐BB ECP520BB PP‐30BB GX05‐9‐7/8 GX‐05‐9‐7/8 PX05‐9‐7/8

LD10‐10 LD‐10‐10 WP1BB20P 1238939 WP.Zs 20‐20 HC‐90‐1 ECP‐5‐BB GX01‐9‐7/8 GX‐01‐9‐7/8 PX01‐9‐7/8

LD10‐20 LD‐10‐20 WP5BB20P 1238938 WP.Zs 10‐20 HC‐90‐5 ECP‐5‐20BB GX10‐10 GX‐10‐10 PX10‐10

LD20‐10 LD‐20‐10 WP25BB20P 1238937 WP.Zs 05‐20 HC40‐0.35 ECP‐5BB GX05‐10 GX‐05‐10 PX05‐10

LD20‐20 LD‐20‐20 WP1‐BB97P 1238936 WP.Zs 01‐20 HC40‐035 ECP‐520BB GX01‐10 GX‐01‐10 PX01‐10

LD30‐10 LD‐30‐10 WP5‐BB97P 1238943 WP.Zs 20‐29 1/4 HC40‐1 ECP‐5‐20‐BB GX10‐20 GX‐10‐20 PX10‐20

LD30‐20 LD‐30‐20 WP10‐BB97P 1238942 WP.Zs 10‐29 1/4 HC40‐5 ECP‐5‐BB GX05‐20 GX‐05‐20 PX05‐20

LD50‐10 LD‐50‐10 WP25‐BB97P 1238941 WP.Zs 05‐29 1/4 HC90‐1 ECP‐520‐BB GX01‐20 GX‐01‐20 PX01‐20

LD50‐20 LD‐50‐20 WP1‐BB20P 1238940 WP.Zs 01‐29 1/4 HC90‐5 PX05‐30

LD01‐9.875 WP5‐BB20P 1238947 WP.Zs 20‐30 HC400.35

LD01‐20 WP2‐5BB20P 1238946 WP.Zs 10‐30 HC40035

LD05‐9.875 WP1‐BB‐97P 1238945 WP.Zs 05‐30 HC401

LD05‐20 WP5‐BB‐97P 1238944 WP.Zs 01‐30 HC405

LD10‐9.875 WP10‐BB‐97P 1238951 WP.Zs 20‐40 HC901

LD10‐20 WP25‐BB‐97P 1238950 WP.Zs 10‐40 HC905

LD20‐9.875 WP1‐BB‐20P 1238949 WP.Zs 05‐40

LD20‐20 WP5‐BB‐20P 1238948 WP.Zs 01‐40

LD30‐9.875 WP25‐BB‐20P 1238955 WP.Zs 20‐19 1/2 XK

LD30‐20 1238954 WP.Zs 10‐19 1/2 XK

LD50‐9.875 1238953 WP.Zs 05‐19 1/2 XK

LD50‐20 1238952 WP.Zs 01‐19 1/2 XK

1238960 WP.Zs 20‐20 XK

1238959 WP.Zs 10‐20 XK

1238958 WP.Zs 05‐20 XK

1238957 WP.Zs 01‐20 XK1238957 WP.Zs 01 20 XK

1238964 WP.Zs 20‐29 1/4 XK

1238963 WP.Zs 10‐29 1/4 XK