Assembly instructions 1/2

- Check the alignment front framerear frame

1

2

Inserts Guide slot

NOTE: Place the steering column by turning the handlebar, so that the "T" at the bottom of the column can be easily �tted into the pulley.

- Reaching the rear frame parallel to the front frame. Taking o� the rear wheel and slide the inserts in the front frame guide slot.

TIP : If you already have installed the TOP SIDE TUBE, check not to pinch the cable front brake between the steering column and tube rack.

Assembly instructions 1/2

- Place the screw A et B*.

TIP : To facilitate priming tightening,you can slightly lift the rear frame.

- Tighten strongly

3

4

Screw A

Screw B

Adjustmentscrew

* The quick release is optional on some models.

Assembly instructions 2/2

- Gently tighten the two adjustment screws located on the steering pulley, with a Allen wrench.

Check the smooth steering

Steering pulley

Steering pulley

5 - Tighten the front brake lever on the handlebar.

Check the brake.

IMPORTANT: To separate the frame, follow the instructions exactly in reverse order of the assembly. Observe particularly Step 4 .The failure to not unscrew the adjustment screws on the steering pulley before separating the two parts, could damage it.