AV8180/8360 RECESSED UNIT RETROFIT INSTRUCTIONS

1. REMOVE 2 FLAT HEAD SCREWS FROM THE CAMERA AND REMOVE RETAINING RING AND DOME. 2. REMOVE RECESSED ADAPTER WITH LEVER SCREWS AND LEVERS FROM THE BOX . 3. INSTALL RECESSED ADAPTER ON THE CAMERA USING 2 #6 FLAT HEAD SCREWS. 4. CUT 8.50” (216MM) ROUND HOLE IN THE CEILING.

PIC.1

PIC. 2 PIC.3

5. TURN 3 LEVER SCREWS COUNTERCLOCKWISE UNTIL LEVERS WILL BE POSITIONED ALONG THE CAMERA HOUSING (SEE PIC. 3)

6. INSERT CAMERA INTO THE HOLE. NOTE: YOU HAVE TO TILT CAMERA SLIGHTLY TO GET IT INTO THE HOLE. 7. PUSH CAMERA IN UNTIL FLANGE WILL REST ON THE CEILING SURFACE 8. TURN EACH OF THREE LEVER SCREWS CLOCKWISE, USING CONVENTIONAL PHILLIPS SCREWDRIVER,

UNTIL CEILING “SANDWICHED: BETWEEN LEVERS AND FLANGE. DO NOT OVER-TORQUE THE LEVER SCREWS

9. REMOVE RECESSED RETAINING RING AND PLACE ACRYLIC DOME INTO THE RING FACING DOWN. 10. MATCH HOLES IN THE DOME WITH HOLES IN RETAINING RING 11. INSTALL RETAINING RING AND DOME ONTO THE FLANGE, USING TWO #4 FLAT HEAD SCREWS FROM

STEP 3. NOTE THAT SCREEWS MUST GO THRU FLANGE AND ACRYLIC DOME MATCHING HOLES. 12. INSTALL REMAINING TWO #6 FLAT HEAD SCREWS.