Upload
kirstie-waters
View
224
Download
0
Embed Size (px)
Citation preview
8/7/2019 Back-Pack Instructions
http://slidepdf.com/reader/full/back-pack-instructions 1/1
Gorgeous Back-Pack Stampin Up! A4 Card Stock
Stampin Up! Crop-A-Dile
Stampin Up! Ribbon
Stampin Up! Designer Series Paper co-ordinated with card-stock
Scorer, Cutter, Ruler, Pencil, Tape/Glue
1. Cut A4 Card to 15cm x 30cm. With the 30cm side at the top of your scorer, score at 4cm, 14cm, 18cm and
28cm. You should have 2cm leftover this is your flap. Fold the 2cm flap. Cut at this fold as shown below in
image. With the shorter end at the top of your scorer, score at 4cm. Turn your card so that the 2cm flap is
on the left, and the 4cm score line is at the bottom.
2. Punch 2 holes with the Crop-A-Dile in the top centre of the left section of your card. Make the holes 0.5cm
apart. Punch 2 holes just above the bottom score lines, each hole should be 1.5cm from the left or right
score lines.
3. Cut at the 4cm Vertical score line from the bottom until you reach the 4cm horizontal score line. Cut at the
14cm score line from the bottom until you reach the 4cm horizontal score line. Cut at the 18cm score line
from the bottom until you reach the 4cm horizontal score line.
4. Attach the ribbon on the inside of the backpack by threading it through the holes made in Step 2. Secure the
ribbon by tying knots on the reverse side of card or by using tape.
5. Cut another piece of Card for the pocket so that it measures 14cm x 8cm. Score at the 2 and 3cm mark on 3
of the four edges. Cut out the corners.
6. Fold the pocket up. Cut a flap and glue onto the back of the pocket. You may wish to round the flap.7. Cut a piece of Designer Series Paper and stick on the front of the back-pack. Glue the pocket overtop.
8. Cut another panel of DSP to hide your ribbon ends on the inside of the back-pack and on the front of your
pocket.
9. Embellish. You may wish to stick a name on the backpack or simply decorate with flowers or hearts.
Kirstie Waters
New Zealand