Upload
others
View
3
Download
0
Embed Size (px)
Citation preview
Installation Instructions
Adjustablewrench
Channellocks
Plumbers’ puttyor caulking
Flat headscrewdriver
Cross headscrewdriver
Hexagonalkey
Bath Tub WastesUS-BTW0231C / US-BTW0231N
Introduction
Tools required
The bath tub waste has been fully inspected throughout the production process and only leaves our factory after a 15 stage QC process.Carefully remove the bath tub waste from the box and check that all parts have been supplied.Before beginning installation of the bath tub waste please check for any damage that may have occurred during transport.Improper installation shall result in loss of warranty in case of damage caused by impacts or rubbing against rough surfaces.IMPORTANT: Please read these instructions carefully before you begin and retain for future reference.We do not accept responsibility for any problems that may occur through incorrect installation.
NOTES: The installation must comply with all plumbing codes including local codes.
Take all necessary precautions to ensure the bath is protected during installation.IMPORTANT: Do not overtighten the waste as this may cause damage. Use a torque wrench set to a torque force of between 18.5 lbf.ft and 36.5 lbf.ft.
WARNING! Please check for any hidden pipes and cables, electric or otherwise before drilling holes.
Installation notes
Maintenance
function of this product. The product should only be cleaned with soapy water then rinsed with clean water and dried with a soft cloth.
TUBOVERFLOW
FACE PLATE
TUBDRAIN
WASHER
WASHER
WASTE BODY
FIXING SCREW
US-BTW0231C/N Bath tub waste
Installation
Install the waste onto the bath as shown in diagram above.
to be sourced by the installer.
Warranty; All Crosswater products come with a limited lifetime warranty. For full details, terms and conditions visit our website.For further information contact; Crosswater London, 393 Fortune Blvd., Milford, MA 01757 www.crosswater-bathrooms.com Toll free number: 844-XWATER-1 (844-992-8371) tel: 508-381-0433 fax: 508-381-6068 email: [email protected]
Issue date: 181017
37 /8”3”
11/8”
15/8”
23 /4”
15/8”
37 /8”37 /8”
21 /2”21 /2”
3/8”
3/8”
11/8”
11/8”
Ø23/4”
23 /8” 35 /8”
2 1/8”G1 1/2
25 3/8”Ø11/4”
35 /8”
7/8”
3 /4”3 /4”
1”1”
US-BTW0231C/NScrew
totallength
threadlength
min. baththickness
max. baththickness
Screw 1 11/16” 15/16” 5/8” 13/16” Screw 2 15/16” 3/4” 7/16” 5/8”
Tub thickness ranges from 9/16” to 3/4” please check and use the