Upload
dudumbaya
View
215
Download
0
Embed Size (px)
Citation preview
8/3/2019 BBIT 313 Unit 1 Introduction Definitions and Data Transmission
1/13
TOPIC 1: INTRODUCTION, DEFINITIONS &DATA TRANSMISSION
SLIDES PREPARED BY: MSAGHA.J.MBOGHOLI
8/3/2019 BBIT 313 Unit 1 Introduction Definitions and Data Transmission
2/13
Data communication: communication of infoby electronic means, usually over somedistance.
Networks allow people to be connectedtogether: advantages of this?
Connectivity and communication, datasharing, hardware sharing, internet access,
internet access sharing, data security andmanagement, entertainment, etc
8/3/2019 BBIT 313 Unit 1 Introduction Definitions and Data Transmission
3/13
Bit rate
Baud
Baud rate
8/3/2019 BBIT 313 Unit 1 Introduction Definitions and Data Transmission
4/13
Parallel transmission data transmitted viaparallel mode on buses with the width of theparallel bus matched to the word size of thecomputer.
In parallel transmission bits are sentsimultaneously on different channels withinthe same cable, or radio path, and
synchronized to a clock
8/3/2019 BBIT 313 Unit 1 Introduction Definitions and Data Transmission
5/13
The parallel transmission bit rate is fasterthan serial transmission bit rate.
However cost of wires needs to be considered
Also as distance becomes longersynchronization timing between multiplechannels becomes more sensitive
Timing is provided by a constant clocking
signal and therefore considered synchronous
8/3/2019 BBIT 313 Unit 1 Introduction Definitions and Data Transmission
6/13
How can we illustrate parallel transmissionusing a diagram?
Serial transmission: Bits are sent sequentially on the same
channel.
Reduced cost but also slower transmission
speed.
8/3/2019 BBIT 313 Unit 1 Introduction Definitions and Data Transmission
7/13
Serial transmission can be either synchronousor asynchronous.
Synchronous
Asynchronous How can we illustrate this in a diagram?
8/3/2019 BBIT 313 Unit 1 Introduction Definitions and Data Transmission
8/13
Applications? Serial: between two computers or from
computer to an external device located somedistance away, e.g., computer to modem.How does this happen?
Parallel: either takes place within a computersystem (on the bus) or to an external device
located a short distance away, e.g., computerto printer
8/3/2019 BBIT 313 Unit 1 Introduction Definitions and Data Transmission
9/13
UART (Universal Asynchronous ReceiverTransmitter): acts as the interface betweenthe parallel transmission of the computer busand the serial transmission of the serial port.
Performance capability depends on amount ofon-chip memory possessed.
8/3/2019 BBIT 313 Unit 1 Introduction Definitions and Data Transmission
10/13
Asynchronous: character by charactertransmission
1 character = a series of bits
Receiver needs to be synchronized with thesender.
Each character will possess a start and stopbit.
Can we show this in a diagram?
8/3/2019 BBIT 313 Unit 1 Introduction Definitions and Data Transmission
11/13
Synchronous transmission: block by blocktransmission.
Receiver is synchronized with sender PRIOR totransmission of continuous stream.
Receiver tunes-in to group of bits beingtransmitted by sender.
Normally makes use of a SYNchronizing
character.
8/3/2019 BBIT 313 Unit 1 Introduction Definitions and Data Transmission
12/13
Differences: Asynchronous: char by char; each char has
start and stop bit; useful in instances ofintermittent transmission of small amounts ofdata; slow therefore not suitable fortransmission of large amounts of data;overhead of extra bits added to each char
Synchronous: block by block requires SYNchar; each block has stop bits; inefficient forintermittent short messages (why?)
8/3/2019 BBIT 313 Unit 1 Introduction Definitions and Data Transmission
13/13
Acknowledgement: Salim Athman