2
THE LOOK AND FEEL OF NATURE Belvedere FIRE PIT

Belvedere FIRE PIT - OBERFIELDS · 2011. 12. 29. · 2. Mark out the location for your fire pit. Note dimensions shown are nominal so mark an area slightly larger than shown. 3. Excavate

  • Upload
    others

  • View
    4

  • Download
    0

Embed Size (px)

Citation preview

Page 1: Belvedere FIRE PIT - OBERFIELDS · 2011. 12. 29. · 2. Mark out the location for your fire pit. Note dimensions shown are nominal so mark an area slightly larger than shown. 3. Excavate

T H E L O O K A N D F E E L O F N A T U R E

BelvedereFIRE PIT

Page 2: Belvedere FIRE PIT - OBERFIELDS · 2011. 12. 29. · 2. Mark out the location for your fire pit. Note dimensions shown are nominal so mark an area slightly larger than shown. 3. Excavate

FEATURESBeautiful Natural stone texture.•Larger, • distinguished scale.One Pallet• has all of the stones, the caps, and the steel ring.Dimensional = • fast installation and no waste. Multiple • natural color blends available.

Integrates seamlessly• with all Rosetta products.

Instructions

Familiarize yourself with the constructions details shown on this 1. page. Mark out the location for your fire pit. Note dimensions shown are 2. nominal so mark an area slightly larger than shown. Excavate for drain stone base (approx. 6”) 3. Fill excavated area with drain stone, level, and compact. The 4. finished height of the fire pit will be approximately 14.25” above base. Place and center steel ring on prepared base. 5. Place 3” and 6” high blocks per the pattern shown below. Keep 6. the back of the blocks approximately 2” off of the steel ring. After placing blocks around the ring, adjust the blocks in or out 7. to make the circle close and fit tight. If the blocks do not close the circle, move all blocks slightly in. If the blocks seem too long, move the blocks slightly out. Fill gap between ring and blocks with small washed stone (p-8. gravel). This step will hold the ring in the center of the fire pit. Place caps in circle around fire pit. Adjust the caps in or out to 9. make them fit tightly together. Caps should slightly overhang the front of the blocks and be slightly forward of the outside edge of the steel ring. Enjoy!10.

Fire Pit Pallet: 1,275 lbsEach pallet contains all of the 6’ tall,

3” tall, and cap pieces needed to

create the fire pit shown below. The

fire pit can be ordered with a black

steel ring, but ring is sold separately.

BelvedereFIRE PIT

Rosetta Hardscapes, LLC products are not intended for direct exposure to intense heat or open flame. Exploding concrete may cause severe bodily injury and/or property damage.

614-252-0955 • 419-225-6761 Toll Free: 800-845-7644www.oberfields.com

inviting, enhancing, enduringwww.discoverrosetta.com