Industrial & Production Engineering (IPE) DHAKA UNIVERSITY OF ENGINEERING &

TECHNOLOGY(DUET), GAZIPUR-1700

Presentation On

Industrial Training

Presented by-Sayem Mahmud (117012)Abdur Rahman (117015)Shariful Islam (117019)Bazlur Rashid (117030)

Training atBangladesh Machine Tools

Factory (BMTF) Ltd.

(BMTF) Ltd. is one of the largest company enterprises in Bangladesh Management under the Bangladesh Army; Located at Gazipur about 40km away from Dhaka.

BMTF is well equipped with variety of high production machineries and equipment’s.

1. PATTERN

The foundries are served with ‘In House’ pattern making facilities

There are five(5) tools used for pattern making, which are:-

Measuring instrument Cutting tools Helping tools

Marking tools Planning tools

2. CASTING

The mechanized foundries of BMTF are the largest in Bangladesh

output of about 5000 tons per year.International quality standardsLine Hardware, Two case centrifugal Pump, Hand

Tube Well

3. FORGING

Equipped with all kinds of forging machines like hammer, presses and special forging machines.

To make best quality product used die and subsequent heat treatment facilities.

3. FORGING(CONTINUED)

A forming press, commonly shortened to press, is a machine tool that changes the shape of a workpiece by the application of pressure. Presses can be classified according to their mechanism: hydraulic, mechanical, pneumatic; and their function: forging presses, stamping presses, press brakes, punch press, etc.

3. FORGING(CONTINUED)

Drop hammerA machine consisting of an anvil or base aligned with a hammer that is raised and then dropped on normalized metal, used to forge or stamp the metal resting on the anvil.

4. PROJECTS

Rice crasher machine Guti Urea Maker Power Tiller

Sugarcane Power Crasher Harvester Pump

5. ASSEMBLY

THERE ARE SIX(6) STAGES IN THE ASSEMBLY LINE

FRAME AXLE LINE PIPE LINE

ENGINE & TRANSMISSION LINE

TRANSFER INSTALLATION LINE

CABIN INSTALLATION

FRAME

AXLE LINE AXLE LEAF SPRING DISH WHEEL SUSPENSION

PIPE LINE PIPING HARNESS BRACKET AIR TANK

ENGINE & TRANSMISSION LINE ENGINE SUB ASSY RADIATOR PITMAN

TRANSFER INSTALLATION LINE TRANSFER LINE PROPELLER SHAFT FUEL TANK

CABIN INSTALLATION DASH BOARD STEERING COLUMN SEAT

STEERING GEOMETRY

Camber Angle: Camber is the angle of the wheel relative to the road

Caster Angle: Caster is the angle of the wheel relative to the axis line.

Toe in:Toe in occurs when two wheel are “A” shape.

Toe out: Toe out occurs when two wheel are “V” shape.

Heat Treatment

Heat treatment is the process of heating and cooling metals to achieve desired physical and mechanical properties.

The processes of heat treatment1. Carburizing2. Quenching3. Tempering 4. Induction hardening

CARBURIZING

Carburizing is a heat treatment process in which iron  or steel absorbs carbon liberated when the metal is heated in the presence of a carbon bearing material, such as charcoal or carbon monoxide.

1. It has 30 pieces coil around the furnace.

2. The capacity of coil is 30 ohm.3. It can heated the job 950 °C.4. The temperature maintained until at

least 6 hours.5. Then the switch was off and cooled

the w/p in the furnace at 250 °C temperature.

CARBURIZING(continued)

THANK YOU FOR PATIENT HEARING