Upload
vegaskink
View
332
Download
0
Embed Size (px)
DESCRIPTION
Bosu ball Pro assembly instructions
Citation preview
1
Bosu Rim Replacement (D-Ring) Kit
Parts Include Tools Required(2) 10-24 x 7/8 Serrated Bolt (1) 5/16" Ratchet and Socket (Remove bolt)(2) 10-24 Serrated Nut (1) 3/8" Ratchet and Socket (Remove nut)(2) Rims(1) Assembly Instruction
Fig 1
Place your Bosu upside down so that the blackbase is facing upward. Pull the plug out to deflate (FIG 1)
Fig 2With the 5/16" ratchet/socket and 3/8" ratchet/socket,
DISCARD OLD NUT AND BOLT
KEEP THE D-RING
remove the bolt, nut and D-Ring from each side. (Fig 2)
Bottom of Bosu
Side of Bosu - nut/bolt area
Plug at the bottom of Bosu
Bladder
Rim
Platform
Serrated Bolt Area Serrated Bolt Area
2
Fig 3
After removing the fasteners and D-Ring,remove the rims, make sure the bladderis positioned as shown on the base.
To aid in positioning the rim on the Bosu,the lip of the bladder must fit flat on the platform.
ATTACHING THE REPLACEMENT RIMS
Fig 4
Set the base and bladder on a flat surface.Align the rims and push them onto theplatform / bladder.
NOTEFor correct alignment of the rims to theplatform, the tab on the inside of one of therims must slide into the notch on the platform.See figures 5 & 6
Fig 5 Fig 6
Notch on Platform
Tab slides into the platform
notch
3
Fig 7Insert the bolt through the mounting hole on the D-Ringthen insert the bolt through the mounting holes on the rim
Tighten the bolt with a 5/16 ratchet/socket and a
Fig 8
BoltNut (opposite side)
Repeat on other side
INFLATING YOUR BOSU:
(Use the pump that came with your Bosu).Place your Bosu flat on the floor with the platform side up. Press against the center of the vinyl andhold the valve opening in place. Insert the pump nozzle firmly and begin to inflate. Inflate your Bosuuntil the bladder feels firm to touch. It's a good idea to lubricant the plug with Vaseline® or otherpetroleum based lubricant. Lubricating the plug will facilitate easy insertion and removal.
Inflate your Bosu to approximately 9 inches high. DO NOT exceed 10 inches high.
and thread the nut onto the bolt. Fig 7
3/8 ratchet/socket. Fig 8D-Ring
Rims