Britax B Ready Manual

8/9/2019 Britax B Ready Manual

1/32

B-READY Stroller User Guide

IMPORTANT: To ensure your child is as safe as possible, read all instructions thoroughly before using this stroller. Store this manual forfuture reference.


2/32


3/32

2010 Britax Child Safety, Inc. All rights reserved. Printed in China. P385000_R4:08.10This product and its components are subject to change without notice.

Warnings Features In the Box Assembly Operating Instructions

Parking Brake Attaching the Seat Detaching the Seat Folding

Swivel Wheels Leg Rest Reclining Handle Angle

Securing Your Child Infant Car seat Mode

Attaching Britax Infant Car seat Adapters Removing Britax Infant Car seat Adapters

Attaching a Britax Infant Car seat Removing a Britax Infant Car seat

Accessories Other Available Accessories B-READY Stroller Configurations

Care and Maintenance Warranty

Table of Contents


4/322

Section TitleWARNING!DEATH or SERIOUS INJURY can occur:

Never leave child unattended. Avoid serious injury from falling or sliding out. Always use harness to

secure child. Do not use stroller for an infant younger than 6 months without an

infant car seat or bassinet. Do not use stroller with a child who weighs more than 55 lbs (25

kg). Do not use stroller with a child taller than 44 inches (111.8 cm).

Do not overload basket Maximum weight in basket is 10 lbs (4.5kg). Overloading the basket may cause the stroller to becomeunstable.

Do not overload the storage pouch - Maximum weight in storagepouch is 1 lb (0.45 kg).

Do not overload the seat-back storage pockets - Maximum weight instorage pockets is 1 lb (0.45 kg).

Do not overload the cup holder - Maximum weight in cup holder is1 lb (0.45 kg).

Do not place hot liquids in the cup holder. Always make certain that the stroller is fully open and locked before

use. Assembly of this stroller must be performed only by an adult.

Do not hang or place items on the stroller handle or frame exceptfor those approved by Britax. They may cause the stroller to becomeunstable.

Only use Britax approved child restraints or car seats with thisstroller.


5/32

Section Title

Do not allow children to climb on or play with the stroller. Never use stroller on stairs or escalators. To avoid entrapment or pinching, do not fold or unfold stroller when

child is in or near stroller. Stroller is intended for walking speed only. Do not use while jogging,

skating, etc. Always set the parking brake when stroller is not moving. Only use accessories and replacement parts approved by Britax

Child Safety, Inc. Do not lift the stroller by the arm bar of the seat. Read and understand these instructions before using this product.

To ensure proper use, store this user guide in a convenient placeso it can be consulted often. Failure to follow all warnings andinstructions could result in serious injury or death.

When using an infant car seat with this product, refer to the productsuser guide for maximum weights and other instructions.

Do not exceed the manufacturers maximum weight limit when usingan infant car seat with this product.


6/324 Actual product may vary from images.

Canopy

ChassisLockOn right sideof frame

Arm Bar

Harness

Buckle

Leg Rest

Front Wheels

Rear Wheels

Rear WheelRelease Button

Mud Guards

Storage Pouch

Frame

ReleaseLever

HandleHeight

Adjuster

Seat Locking LatchChassis Socket

Release Lever

Under-SeatStorageBasket

SwivelWheelLocks

Front WheelRelease

Features


7/32

Front Wheels x2

Storage Pouch

Rear Wheels x2 Main Seat

Arm Bar

CupHolder

Stroller Frame

Rain Cover

Mud Guards x2

Britax Infant Carseat Adapters

In the Box


8/326

Lift chassis lock lever andopen the frame

Lift handle until frame locksinto upright position asshown

Slide mounting pins into thehousing on the frame untilthey lock into place

NOTE: The Britax logo imprintedon the wheel should be facing theoutside of the stroller

Unfolding

Front Wheels

Assembly


9/32

Rear WheelHousing

NOTE: Left and right wheels are marked with an L or R and are fromthe perspective of standing behindthe stroller

Hold in the release button in

the center of the wheel andslide the mounting pin intothe housing on the rear axle

Slide the mud guard ontothe mounting bracket aboveeach rear wheel housinguntil it locks into place

Rear Wheels

Mud Guards

Assembly


10/328

Attach hook and loop stripto the strip on the inside ofthe under seat basket

Attaching: slide the pins intothe mounts on the seat untilthey lock into place

Removing: push the releasebutton on the bottom of themounts and pull arm bar out

NOTE: Armbar or cup holders must always be used to avoid fingerentrapment in the open connectors

Arm Bar

Slide the hook and loopfasteners on both sides ofthe pouch through the tabsabove each back wheel

Storage Pouch

Assembly


11/32

Press and hold the release

button in the center of thewheel and pull away fromthe wheel housing

Line up the arrow with thepin just below the foldingrelease lever and snap thecup holder mount onto theframe

Removing Front Wheels

Removing Rear Wheels

Cup Holder

To remove, rotate the capin the direction indicatedby the arrows until wheelreleases

Assembly


12/3210

Parking Brake

Attaching the Seat

Step on the brake pedal

until the indicator windowchanges colorRed indicates the brake is engaged

and green indicates the brake is off

Insert the seat lockinglatches into both chassissockets

Push down until an audibleclick is heard

NOTE: Seat attaches forward or rearfacing

Operating Instructions


13/32 1

Detaching the Seat

Pull up on the seat to ensurethat it is locked into placecorrectly

IMPORTANT: Always remove child before detaching the seat

Lift both release levers oneach seat locking latch atthe same time

Lift upward



14/3212

Always apply brake and remove

children before folding the stroller Pull up both frame releaselevers located just belowthe stroller handle, and stepback while guiding strollerdownward

Continue folding until thechassis lock engages

TIP: You may need to compress theframe to engage the chassis lock

Toggle the wheel lock on

the back of the front wheelhousing up or down.Down will lock wheelsforward and up will allowwheels to swivel

Folding

Swivel Wheels



15/32 1

Depress buttons on both

sides of the leg rest hingeand hold while raising orlowering the leg rest to thedesired position

Lift and hold the reclinelever on the back of the seatand hold while raising orlowering the seat back to thedesired position

Depress and hold the two

release buttons on the insideof the handle assemblywhile raising or loweringthe handle to the desiredposition

Leg Rest

Recline

Handle Angle



16/3214

Release the harness bydepressing the button in thecenter of the buckle whilepulling the two top tonguesaway from the buckleassembly

Sit child in seat and unzipthe seat back to access theharness height adjuster

TIP: You may need to loosen the harness to adjust the harness height.

Squeeze the adjuster torelease and slide up ordown to one of the three

positionsNOTE: Adjusted harness height

should be at or above the shouldersof the child

Securing Your Child


17/32 1

Tighten or loosen theharness straps by sliding theharness adjusters

Buckle tongues separate for added safety. To reconnect buckle tongues,line up the two pieces and slide theupper portion onto the track on thelower piece

Buckle the harness bypressing the tongues onthe harness straps into thebuckle assembly

NOTE: Ensure the straps are not twisted as they may becomeuncomfortable for the child

Securing Your Child


18/3216

Attaching Britax InfantCar seat Adapters

Slide each of the adaptersunder the infant car seathandle and into the shelluntil they click into place

There is a left and right adapter andorientation should be as shown

Pull downward on theadapter to ensure that it issecure

Removing Britax InfantCar seat Adapters

Pull the release lever andslide the adapters down andout of the infant car seatshell

Infant Car seat Mode


19/32 1

Attaching a BritaxInfant Car seat

Align the adapters and insertinto both chassis sockets

Push down until a click isheard

Pull up on the seat to ensurethat it is secure



20/3218

Removing a Britax InfantCar seat

Lift both release levers oneach seat locking latch atthe same time

NOTE: When removing infant car seatfrom stroller, take care that the car

seat does not tip and fall

Lift upward

NOTE: Once the infant car seat adapters are installed, they do not need to be removed. The infant car seat will fit into the vehicle base whilethey are attached

WARNING

The infant car seat adapters are ONLY compatible with Britax infant car seat and ONLY models from 2009 or newer

Attempting to fit them into another infant car seat candamage the car seat or cause the car seat to fall

Use the universal adapter (sold separately) for infant car seats other than Britax infant car seats



21/32 1

Rain Cover

Extend the canopy andlay the rain cover over thecanopy until the recline leverlines up with the slot on theback of the rain cover

Slide the elastic strap underthe foot rest to the bottom ofthe seat

Pull the bottom of the raincover over the footrest

Accessories


22/3220

Turns the B-READY Strollerinto a two seater and can beused with Infant Car seat Mode

Easy storage for drinks andsnacks

Turns the B-READY Strollerinto a bassinet style strollerand can be used with thesecond seat

Protects your child from sunand insects while enjoying theoutdoors

Second Seat

Child Cup Holders

Bassinet

UV/Mosquito Cover

Other Available Accessories


23/32 2

Makes the stroller compatiblewith major manufacturersinfant car seats

Allows an infant car seat to beattached closer to the parentand works with either a seat oran infant car seat in the upperposition - Great for twins

Extra protection from the coldfor your child

Universal Infant Carseat Adapter

Lower Infant Car seat Adapter

Boot Cover Travel Bag

Other Available Accessories


24/3222

Shown with optional accessories (sold separately)

B-READY Stroller Configurations


25/32 2

Extension adapters MUST be used in this configuration*

*



26/3224

Shown with optional accessories (sold separately)

Extension adapters MUST be used in this configuration*

* *



27/32 2

Care and Maintenance

Parking Brake Periodically check that the parking brake works properly and locks bothwheels securely Clean out any dirt or debris that may prevent the brake from workingFrame Wipe the frame with a damp cloth and mild soap Use clean, dry cloth ortowel to wipe away excess water and soap

Fabric and Harness DO NOT machine wash or dry the cover Hand wash with cold water and mild soap Air dry to prevent the coverfrom shrinkingCleaning Plastic Parts: Wipe with a damp cloth and mild soap Use clean, dry cloth or towel towipe away excess water and soap DO NOT use abrasives, solvents, strong detergents, or householdcleaners DO NOT iron

Maintenance If stroller gets wet wipe with a clean cloth or towel to prevent corrosion DO NOT fold stroller when wet or damp Always make sure that thestroller is dry before storing

Plastic Parts DO NOT use abrasives, solvents, strong detergents, or householdcleaners These products can scratch, discolor, and weaken plastic or

cause corrosion on metal surfacesStorage Store away from extreme heat to prevent damage to plastic parts Cover stroller to prevent dust build-up and exposure to sunlight DO NOT stack other items on top of stroller


28/3226

This product is distributed by Britax Child Safety, Inc Britax Child Safety, Inc (Britax) warrantsthis product to the original retail purchaser as follows:

Limited Two-Year Warranty

This product is warranted against defective materials or workmanship for two years fromthe date of original purchase Proof of purchase is required Your exclusive remedy forthis warranty is that Britax will, at its option, provide repair or replacement components tothe original purchaser for this product or replace the product Britax reserves the right todiscontinue or change fabrics, parts, models or products, or to make substitutions Labor andshipping costs for returns are not included

To make a claim under this Warranty, you must contact Britax Customer Services Departmentat 1-888-4BRITAX or write to 13501 South Ridge Drive, Charlotte, NC 28273 Proof ofpurchase is required

PLEASE COMPLETE AND MAIL THE REGISTRATION CARD WITHIN 30 DAYS OF PURCHASE,OR VISIT WWW.BRITAXUSA.COM/REGISTRATION.

Warranty Limitations

This warranty does not include damages which arise from negligence, misuse, salt corrosion,or use not in accordance with the user guide

The use of non-Britax Child Safety, Inc accessories is not approved by Britax The use ofunapproved accessories could cause this product to become damaged or dangerous Theiruse automatically voids the Britax warranty

Limitations of Damages

The warranty and remedies as set forth above are exclusive and in lieu of all others, oral orwritten, express or implied In no event will Britax or the retailer selling this product be liablefor any damages, including incidental or consequential damages, arising out of the use orinability to use this product

Limitations of Warranties and Other Warranty Terms and State Law Rights

Any implied warranties, including implied warranties of merchantability and fitness for aparticular purpose, shall be limited to the duration and terms of the express written warrantySome states do not allow limitations on how long an implied warranty lasts or the exclusion orlimitation of incidental or consequential damages, so the above limitations may not apply toyou This warranty gives you specific legal rights, and you may have other rights, which varyfrom state to state Neither Britax, nor the retailer selling this product, authorizes any person tocreate for it any other warranty, obligation, or liability in connection with this product

Warranty


29/32 2

Notes


30/3228

Notes


31/32


32/32

Britax Child Safety, Inc.13501 South Ridge DriveCharlotte, NC 28273USA

A Britax Childcare GroupLimited company

Tel. : 1-888-427-4829

www.Britax.com

Visit our website at www Britax com for more information

Documents

Britax B Ready Manual