8/20/2019 Brosur Deltagrout De

http://slidepdf.com/reader/full/brosur-deltagrout-de 1/2

PT. DELTACRETINDO WIRA MANDIRI

Jalan Pintu Air IV No. 41A, Jakarta Pusat - Indonesia

  Telp . +62 21 344 2919 Fax. + 62 21 351 1428■  ■

DELTACON DEDouble Expansion Fluid Micro Concrete for Structural Repair

DESCRIPTIONDeltacon DE is a high strength fluid micro concrete for structural repair, made from well graded filler,

 portland cement and chemical additives which produce a free flowing, shrinkage compensated repair

mortar. Deltacon DE gives a controlled expansion in both the plastic and hardened state; furthermoreDeltacon DE has excellent bonding without needing any primer.

USESDeltacon DE is especially designed and used for structural repair; to be pouring at congested

reinforcement area, especially for column, beam or slab dimension enlargement or for filling the voids inconcrete repair works.

ADVANTAGES

·Double expansion system that ensuring short term and long term shrinkage in your repair method.

·Easy to use; pre packed – only clean water is needed.

·Pump-able which may be needed for your repair method.

INSTRUCTION FOR USE

Surface PreparationIdentify the repair area, saw cut or cut back the extremities of the repair location to a depth 10 mm to

 provide a square edge and to avoid delaminating. Clean the surface and remove any dust, unsound or

contaminated material. Any loose material on repair area may exhibit poor bonding. If any, reinforcement

 bar should be cleaned from corrosion deposits – grit blasting is recommended.Formwork on the repair area should be rigid and tight, made from non absorbing materials – to preventwater loosing for Deltacon DE.

ApplicationA mechanically powered grout mixer should be used for best results; a slow speed mixer should be used

for quantities up to 50 kg. Before application it is better to ensure your mixing capacity and labor to beable to have continuously pouring method, when using pumping method please consult with the pumpmachine supplier for maximum capacity per batch.

Deltacon DE is supplied in 25 kg bag, which needs 3 - 3.5 litres waters per bag. Clean water is minimum

requirement for best quality. Put the 2/3 of water into mixing bowl, pour Deltacon DE slowly as the mixer blend them thoroughly, pour the rest of the water to adjust your consistency mixture.

Deltacon DE has to be poured within 30 minutes after mixing to gain full benefit of the fluidity andexpansion process. Deltacon DE can be placed up to 50 mm thickness in a single pour.

STORAGEDeltacon DE has a shelf life of 12 months if kept in a dry store in its original, unopened bag.

8/20/2019 Brosur Deltagrout De

http://slidepdf.com/reader/full/brosur-deltagrout-de 2/2

C O N S T R U C T I O N P R O D U C T S

PT. DELTACRETINDO WIRA MANDIRI

Jalan Pintu Air IV No. 41A, Jakarta Pusat - Indonesia

  Email : deltacrete@gmail.com Website : www.deltacretindo.com■ ■

Disclaimer :

The information detailed in this brochure is liab le to modification from time to time inthe light of experience and of normal product application, and before using orapplying the product in site, the customer are strongly advised to contact Deltacretefor further more detailed technical guidance. All data shown in the brochure aretypical laboratory result achieved in ideal conditions, site results could be different.Because Deltacrete has no direct or continuous control over where or how itsproducts are applied, Deltacrete can not accept any liability either directly orindirectly arising from the use of its product, whether or not in accordance with anyadvice, specification, recommendation or information given by it.

  Telp. +62 21 344 2919 Fax. + 62 21 351 1428■  ■

 

TECHNICAL DATA

Compressive strength (BS 1881 part 116 1983) 30 N/mm2 @ 3 day

45 N/mm2 @ 7 days

60 N/mm2  @ 28 days

Setting time 6 hours (intial set) – 9 hours (final set)

Fresh wet density (depending on actualconsistency)

Approximately 2270 kg/m3

Coverage or consumption of Deltacon DE Approximately 80 bag /m3 hardened

Deltacon DE 

Modulus of elasticity (BS 1881 part 121 1983) 33 KN/mm2 @ 28 days

Bond Strength – BS 6319 66 N/mm2 @ 28 days

Packaging and Size 25 kg Bag

EALTH & SAFETY

Deltacon DE may cause harm in some skin contact, avoid contact with skins, eyes and inhalation ofvapor. Protective gloves and eye protection are highly recommended during work of application.

ODE B9 - DC 08/2010