Pump shaft / sleeve to be clear of knicks &

scratches where seal o’ring sits. Stuffing

box face to be checked for deep scratches if

seal uses o’ring to seal on this surface

instead of a gasket.

Seal o’ring to be lubricated prior to seal

being installed on pump.

Install seal on shaft & bolt to stuffing

box face positioning seal gland Flush

Port in most suitable position for

piping.

Tighten seal setscrews down onto pump

shaft / sleeve. Remove seal setclips prior to

start up. After removing setclips visually

inspect gap between drive collar & seal

gland – should be uniform all way round.

Cartridge seal installation instructions

1-800 662 0585

WWW.ROBCOAMERICA.COM