CEILING ACCESSORIESRANGE INTRODUCTION

MK Electric offers a comprehensive range of white ceiling accessories for all requirements. Included in the range are enhanced ‘safety’ lampholders.Unlike most other ‘safety’ lampholders, when the lamp is removed Shockguard Plus automatically shields the contact by means of a specially designed shutter and it remains that way until a lamp is replaced.

Therefore when no lamp is in place contact pins are totally isolated, eliminating danger of electrocution.

FEATURES & BENEFITS

EASE OF INSTALLATION

Pendant sets incorporate a heat resistant lampholder, ceiling rose with a transparent base and clear terminal markings for ease of identification. Terminals are grouped in line with neutral, loop-in and earth terminals.

SAFETY

Shockguard Plus has a specially designed shutter that automatically shields the lamp contacts, therefore eliminating the danger of electrocution.

RELIABILITY

All products are 100% tested before delivery for confidence, so a ‘fit and forget’ installation can be achieved. Fully compliant with the relevant British Standards BS 7895 for bayonet lampholders with enhanced safety and BS EN 61184.

DURABILITY

Manufactured from the highest quality materials to give a high gloss finish, which is both scratch and colour fade resistant.

53MK Electric Catalogue

WIR

ING

DE

VIC

ES

WHITE

Ceiling Switches

6 AMPSURFACE

WITHOUT MOUNTING BLOCKSFLUSH

50AFLUSH

Mounting Blocks and Cords

K3191WHI 56A SP ONE-WAY 1.5M WHITE CORD WITH WHITE ACORNK3191D1WHI 56A SP ONE-WAY 2M WHITE CORD AND 1X GRAPHITE BANGLEK3192WHI 56A SP TWO-WAY1.5M WHITE CORD AND WHITE ACORNK3192D1WHI 56A SP TWO-WAY 2M WHITE CORD AND 1X GRAPHITE BANGLE

Supplied with mounting blocks.Earth terminal is riveted in base of mounting blocks. BANGLE DIAMETER 50mmThese switches do not have to be derated when used with fluorescent or inductive loads.FIXING CENTRES 50.8mmBS EN 60669-1:1999

3190RCWHI 56A SP TWO WAY2M RED CORD WITH RED ACORNPULL TO MAKE OR PULL TO BREAK (MOMENTARY SWITCH ACTION)3190RCD1WHI 56A SP TWO-WAY 3M RED CORD AND 2X RED BANGLE

Supplied with mounting blocks.BANGLE DIAMETER 50mmBS EN 60669-1:1999

K3131WHI 56A SP TWO-WAY3151WHI 516A DP ONE-WAY

Mounting blocks are not supplied. Use K2051WHI or K2056WHI.Suitable for installation in small circular conduit boxes to BS EN 61386-1:2008 See page 354.Ceiling switch cords are 1.5m minimum length.These switches do not have to be derated when used with fluorescent or inductive loads.FIXING CENTRES 50.8mmBS EN 60669-1:1999

3164WHI 550A DP ONE-WAY WITH NEON 1.5M WHITE8329SSWHID1T9 52M WHITE CORD WITH JOINT UNION AND GRAPHITE BANGLE

MOUNTING BOXESSurface Moulded 2140WHI, 2180WHI 2031WHI (extra wiring space)Flush Steel 877ZIC (for full load applications)Surface Metal 2211ALM, 2213ALMFitted with a mechanical ‘OFF’ indicator. The switch fully complies with the requirements within BS 7671 IET Wiring Regulations with respect to safety isolation for maintenance purposes and provides a full 3mm contact gap when ‘OFF’.DIMENSIONS 86 x 86mmBANGLE DIAMETER 50mmFIXING CENTRES 60.3mmBS EN 60669-1:1999

K2051WHI 10MOUNTING BLOCK FOR 6A OR 16A SWITCHESK2056WHI 5MOUNTING BLOCK WITH NEON FOR 6A OR 16A SWITCHES8329SSWHIT9 101.5M WHITE CEILING SWITCH CORD COMPLETE WITH ACORN AND ONE PIECE JOINT UNION9420SST9 12M RED CEILING SWITCH CORD COMPLETE WITH TWO RED ACORNS AND ONE PIECE JOINT UNION9420SSD1 103M RED CEILING SWITCH CORD COMPLETE WITH 2 X RED BANGLES AND JOINT UNION

K2051WHI and K2056WHIEarth terminal riveted in base.DIAMETER 76mm not including Neon LensFIXING CENTRES 50.8mmBS EN 60669-1:1999

K3191WHI

K3191D1WHI 3190RCD1WHI

3190RCWHIK3131WHI

3151WHI

K2051WHI

K2056WHI

3164WHI

8329SSWHID1T9 8329SSWHIT9 9420SST9

54 mkelectric.co.uk

WIR

ING

DE

VIC

ES

WHITE mkelectric.co.ukCeiling Accessories

Ceiling Roses Lampholders

K1161WHI 10FOUR TERMINALS LINE, NEUTRAL, LOOP-IN AND EARTHK1163WHI 10CEILING ROSE HALO

Incorporate tunnel type terminals, which accommodate 3 x 2.5mm2 cables and allow for off centre cable entries, transparent terminal block and equal length wire stripping. Suitable for fittings of up to 5kgs. Heavier fittings must be installed using independent support eg. ceiling hook.The ceiling roses are suitable for mounting over BS EN 61386-1:2008 circular conduit boxes. DIAMETER(Cover) 86mmDEPTH(Cover) 34mm3BS 67:1987The Ceiling Rose Halo gives a neat finish should the ceiling be damaged.

K1170WHI 10BC PENDANT LAMPHOLDER WITH AUTOMATIC CORDGRIP AND STRAIGHT SKIRTK1171WHI 10BC PENDANT LAMPHOLDER WITH AUTOMATIC CORDGRIP AND PROTECTIVE SKIRTK1180WHI 10STRAIGHT SKIRT FOR MK LAMPHOLDERSK1181WHI 10PROTECTIVE SKIRT FOR MK LAMPHOLDERS

All MK lampholders are heat resistant to category T2 of BS EN 61184 and are therefore capable of operation with lamp cap temperatures up to 210°C.BS EN 61184:1997 T2 Rated.

K1161WHI

K1163WHI

K1170WHI

K1171WHI

K1181WHI

K1180WHI

The MK Ceiling Rose has a transparent base, precut aper-ture and clear markings for ease of installation. Terminal layout allows cables to be cut to the same length and the earth terminal is positioned for easier cable access.

OFF ON SAFE

Unlike most ‘safety’ lampholders, when a lamp is removed Shockguard Plus automatically seals the contact by means of specially designed shutter and it remains that way until the lamp is replaced.This means that with no bulb in place there is no danger of electrocution from exposed contacts, as the contact pins are fully shielded.

MK Electric Catalogue 55

WIR

ING

DE

VIC

ES

WH

ITE

Technical Hotline +44 (0)1268 563720 Ceiling Accessories

Lampholders

SG TYPE

Pendant Sets

SG TYPE

Batten Lampholders

SG TYPE

1150WHI 10BC PENDANT SG TYPE LAMPHOLDER

Shockguard SG Type lampholders automatically shield contacts by means of a shutter when the lamp is removed.All MK SG Type lampholders are heat resistant to category T2 of BS EN 61184 and are therefore capable of operation with lamp cap temperatures up to 210°C.BS EN 61184:1997 BS 7895:1997

K1186WHI 10150MM PENDANT SETK1189WHI 10230MM PENDANT SET

K1186WHI and K1189WHI incorporate a lampholder (K1170WHI), heat resisting PVC insulated and sheathed flexible 0.75mm2 two core circular cable complying with BS EN 50525-2-11 and a ceiling rose fitted with line, neutral, loop-in and earth terminals (K1161WHI). This assembly will support a light fitting of up to 3kgs.

1146WHI 10SG TYPE 150MM PENDANT SET1149WHI 10SG TYPE 230MM PENDANT SET

1146WHI and 1149WHI incorporate a SG lampholder (1150WHI), heat resisting PVC insulated and sheathed flexible 0.75mm2 two core circular cable complying with BS EN 50525-2-11 and a ceiling rose fitted with line, neutral, loop-in and earth terminals (1174WHI).This assembly will support a light fitting of up to 3kgs.

K1172WHI 10BC ANGLED 1174WHI 10HEAT RESISTANT TAILS, LIVE, NEUTRAL, LOOP-IN AND EARTH TERMINALS

All MK lampholders are heat resistant to category T2 of BS EN 61184 and are therefore capable of operation with lamp cap temperatures up to 210°C.1174WHI also incorporates heat resistant wires connecting the terminals in the base to the lampholder. It has terminals mounted in the base and knockouts which accommodate 3 x 2.5 mm2 cables and allow for off centre cable entries.BS EN 61184:1997 T2 Rated.

1152WHI 10SG TYPE ANGLED BATTEN LAMPHOLDER HEAT RESISTANT TAILS, LIVE, NEUTRAL, LOOP-IN AND EARTH TERMINALS1154WHI 10SG TYPE BATTEN LAMPHOLDER HEAT RESISTANT TAILS, LIVE, NEUTRAL, LOOP-IN AND EARTH TERMINALS

Shockguard SG Type lampholders automatically shield contacts by means of a shutter when the lamp is removed.All MK SG Type lampholders are heat resistant to category T2 of BS EN 61184 and are therefore capable of operation with lamp cap temperatures up to 210°C.1152WHI and 1154WHI also incorporate heat resistant wires connecting the terminals in the base to the lampholder.BS EN 61184:1997 T2 Rated.BS 7895:1997

1146WHI

1149WHI

1152WHI

1154WHI

K1172WHI

1174WHI

K1189WHI

K1186WHI

1150WHI

56 mkelectric.co.uk

WIR

ING

DE

VIC

ES

WHITE mkelectric.co.ukCeiling Accessories

CASE STUDYTHE MALTHOUSE, OXFORD UNIVERSITY – MK PORTFOLIO

Oxford University Estates Services, who are responsible for managing over 350 buildings and properties for the university, have their offices located at The Malthouse in central Oxford.Their fully functional office space has been refurbished utilising a variety of MK products including Prestige 3D Compact and Integrated USB sockets, which were selected due to their superior manufacturing quality, reliability and functionality.

Oxford University Images/David Williams

57MK Electric Catalogue

CA

SE

ST

UD

Y