Modulo Admin sys = Modulo Admins [H3C]display ip int b =
verifica as interfaces [H3C] display current-configuration = Para
ver Nvram [H3C] display interface 0/0 = verificar contadores inter
[H3C]undo = apaga conf [H3C]save = salva config [H3C]display
interface 0/1 = para verificar interfaces [H3C]display version =
verifica ios [H3C]display ip routing-table = tabela routeamento
ativa [H3C]display fr pvc-info = verifica p pvc o protocolo esta up
[H3C]display users = ver quem esta logado [H3C]display
user-interface [H3C]display arp = tabela arpreset
saved-configuration = receta as conf e zera os contadores e rebo ot
delete /unreserved config.ctg = deleta confi sem guardar na memoria
reboot = desliga e liga o router undelete flash:/ = recupera
aquivos deletaDO ,mais presente routeEthernet waw efm atm
[H3C]interface Ethernet 0/0 [H3C-Ethernet0/0]ip address 10.1.1.2
255.255.255.252 [H3C-Ethernet0/0]duplex full [H3C-Ethernet0/0]quit
waw serial [H3C]interface Serial 0/0 [H3C-Serial0/0]link-protocol
ppp * [H3C-Serial0/0]ip address 192.168.2.1 255.255.255.0
[H3C-Serial0/0]quit [H3C] ETHERNET LAN [H3C]interface Ethernet 0/1
[H3C-Ethernet0/1]port link-mode route * [H3C-Ethernet0/1]ip address
192.168.2.1 255.255.255.0 [H3C-Ethernet0/1]duplex full
[H3C-Ethernet0/1]load-bandwidth 2048 [H3C-Ethernet0/1]speed 100
[H3C-Ethernet0/1]quit ***********************
***********************Rota Statica [H3C]ip route-static 0.0.0.0
0.0.0.0 10.1.1.1Config usuario para acesso a router [H3C]telnet
server enable % Start Telnet server [H3C]local-user admin
[H3C-luser-admin]password simple admin
[H3C-luser-admin]authorization-attribute level 3
[H3C-luser-admin]service-type telnet terminal [H3C-luser-admin]quit
Liberando a console e telnet [H3C]user-interface vty 0 4
[H3C-ui-vty0-4]authentication-mode scheme [H3C-ui-vty0-4]quit
Enviar menssagem sen send ? INTEGER all aux tty vtySpecify one user
terminal interface All user terminal interfaces Aux user terminal
interface Async serial user terminal interface Virtual user
terminal interfacesend all Enter message, end with CTRL+Z or Enter;
abort with CTRL+C: asdfghj^Z Send message? [Y/N]:y *** ***
***Message from vty0 to vty0 *** asdfghj Colocar Velocidade
interface ethernet [H3C-Ethernet0/0]load-bandwidth ? INTEGER
Load-sharing bandwidth value (Kbps) [H3C-Ethernet0/0]load-bandwidth
2048 [H3C-Ethernet0/0]
