Ill N c MATERIAL COMPLIANCE STATEMENT International MATERIAL
COMPLIANCE STATEMENT SHEET FOR: FIRE PUMP SET Ref: No.
NGLCTY1-MS-LP-Q021
Revision No. 0 EPIC OF PHASE 1 OF THE NEW NGL SUPPORT CAMPUS AT
MESAIEED Date : 13/02/2014
Spec Ref:NGLCTY1-9-14-0003 REV A S-NO Description Compliance
The impeller shall be of cast bronze enclosed double suction
type, both statically an hydraulically balanced. The impeller shall
be keyed to a shaft. The shaft material shall be steel to the shaft
shall be protected by; sleeves with a gasket joint between it. The
shaft shall be
2 protected by; sleeves with a gasket joint between it and t he
impeller for protection against shaft corrosion. The sleeves will
be bronze Noted&Comply.Grease lubricated bearings are used per
UL/FM requirements to ASTM 8584-932 or equivalent. The sleeves will
be positive drive by means of a key and with an extern sa sleeve
nut set screwed to the shaft for a reduction in shaft wear
The shall be equipped with renewable throat bushings, casing
rings in bronze to ASTM 8584- and inter stage channel ring to
reduce casing wear and maintenance costs. The casing rings and
channel ring shall be hold by Anti-rotational pins to permit easy
reinstallation and reduce down time, impeller wear rings are
optional. The rotating element shall be mounted in (Grease) (Oil)
lubricated ball
3 bearings (when temperatures rise above 225"F. Water jackets
shall be added). Heavy cast split glands shall be furnished on each
Noted&Comply.Grease lubricated bearings are used per UL/FM
requirements stuffing box design for easy removal for packing
inspection and maintenance. Heavy fabricated steel base to mount
the pump and driver shall be furnished. Flexible shaft coupling
shall be furnished to connect the driver pump. Coupling shall be
installed with coupling guard in accordance w ith section 8 of ANSI
8 15.1, Safety standard for Mechan ical power transmission
Apparatus
l-6MOTORS
1 The Motors for Emergency firewater pumps and Training fire
water pumps shall comply with NEMA MG-1, Motors and Generators,
Comply. IEC type motor manufactured by A88 is provided. shall be
marked as complying with NEMA Design 8 standards, and shall be
specifically listed for fire pump service
The main pump set shall be provided with a direct drive, totally
enclosed fan cooled, 2900 rpm, F class insulation, temperature rise
2 restricted to class 8, IP-55 protection type Standard Motor wound
for a 415 volt 3 phase 50 Hz. supply w ith flexible coupling and
Comply. IEC type motor manufactured by ABB is provided.
mounted with motor alignment jacking points
The motor shall fully comply with QP standard ES.2.03.0001
(Electrical Engineering Philosophy) ES.2.14.0030 (LV. Cage
Induction 3 Motor), ES.2.14.0098 (Electrical Requirement for
Package Equipment) NFPA 20 (2013), & NFPA 70[(2011) CONTRACTOR
shall ensure Comply_ IEC type motor manufactured by A88 is
provided.
compatibility of pump and motor in all aspects
The driver shall be selected in accordance with NFPA 20[(2013)
clause 9.5.2 to provide the required power to operate t he pump at
4 rated speed and maximum pump load under any flow condition. All
motors shall be rated for continuous duty. The motors shall not
Comply. IEC type motor manufactured by A88 is provided.
have a service factor greater than 1.1.5.
l-7 DIESEL ENGINE
ElectricalQACHighlight
ElectricalQACHighlight
ElectricalQACHighlight
ElectricalQACHighlight
ElectricalQACHighlight
