Components

• Connection Jig

• Graph Paper (#4101)

• Mounting Blocks (#5902)

• Nails• Tape Measure• Pen

• Hammer

• Customer Coordinates

• Using the Connection Jig (#4095), mount two 5902 Mounting Blocks on each corner of the aluminum panel– The lip on the back of the jig will catch the aluminum panel edges and align the jig in

the corner– Fit the 5902 mounting block in the corner of the jig

• Most mounting blocks will fit in the corner of the jig*

Step 1 – Mounting the 5902 Blocks

Jig Lip

*see next page

Aluminum Panels - odd Mounting

• For the below sizes of aluminum panels, only one 5902 mounting block will be used and the mounting block will need to align with the appropriate block marks pre-printed on the jig.– Align the jig along the left corner of the panel (not the right

side)• 6x6*• 10x10• 11.75x11.75• 11x14 Vertical

*see next page

Pre-printed Block Marks

6”x6” - Special Instructions

• For the 6”x6” panel, it will only catch the top lip of the jig.

• On the left side, line up the inside edge of the jig with the outside edge of the aluminum panel

Line up jig with panel, not bottom lip of jig

Front View Back View

Line up panel at edge of jig, not far side

At top, line up panel at very top of jig

• After adding the mounting blocks to the aluminum panels, please provide the following to your customers– Graph Paper • 4101 pre-printed graph paper with grid lines that can be used for

almost all configurations

– Customer Coordinates*• One-page document for your customers with the coordinates for

their selected configuration • Graph paper includes coordinates and customer hanging

instructions

Packing up

*see next page

Sample Coordinates Page

• Hanging Tools– Graph paper – Coordinates for your selected configuration – Pen (to mark your nail coordinates)– Tape Measure & level (to accurately hang the graph paper)

• Hanging Instructions– Using the coordinates from the Coordinates one-pager, mark the following on your graph

paper:• Coordinates for your nails• Middle of configuration line (use this to center the Connection)• If necessary, cut off the graph paper to the right of where the configuration ends (reference the

configuration end line above)– Using a tape measure, measure down from the ceiling and tape the graph paper to the wall so

it is level– Using the configuration coordinates, hammer in the nails at the connection points– Hammer in the nails at a slight downward angle and leave about ½” of the nail out from the

wall– Remove the graph paper from the wall– Hang the ChromaLuxe panels in their appropriate position

Customer Hanging Instructions (located on customer coordinate page)

• Products to Order: – Aluminum Photo Panels (separately) for each connection

configuration – 5902 Mounting Blocks – 4095 Connection Jig– 4101 Graph Paper

• Introduce ChromaLuxe Connections on your Website

How to get started