Upload
lenga
View
267
Download
0
Embed Size (px)
Citation preview
Mini CONVENTIONAL
FIRE ALARM SYSTEM
EXPERT IN FIRE ALARM
& SAFETY TECHNOLOGY
CONVENTIONAL FIRE ALARM SYSTEM ARCHITECTURE
End of Line Resistor
SmokeDetector
HeatDetector
Smoke & HeatDetector
No.1 Slave Panel
SmokeDetector
HeatDetector
ManualCall Point
SmokeDetector
ManualCall Point
SmokeDetector
HeatDetector
Bell Bell Sound StrobeSoundStrobe
SoundStrobe
DC24V Power
RS485 Communication
DC24+
DC24-
AB
ZONE+
ZONE-
ZONE+
ZONE-
ZO
NE
1
ZO
NE
2
SO
UN
D O
UT
PU
T
4.7K
4.7K
End of Line Resistor
1N40
07D
iode
End of Line Diode
SOUND+
SOUND-
Remote LED Remote LED Remote LED Remote LED Remote LED
Max. 25 detectorsin One Zone
Max. 5 to 10 (1A@24VDC) Sounder & Bell
in One Sound Output
AC Power Input(90-270V)
HOT
NEUTRAL
GROUND
ZO
NE
1
ZO
NE
2
SO
UN
D O
UT
PU
T
ZO
NE
1
ZO
NE
2
SO
UN
D O
UT
PU
T
Max No.31 Slave Panel Master Panel
DC
24V
DC24V Power Supply
DC12Vbattery
DC12Vbattery
Fire
1 A
larm
Rel
ay O
utpu
tN
O
CO
M
Fire
2 A
larm
Rel
ay O
utpu
t
Fau
lt R
elay
Out
put
NO
CO
M
NO
CO
M
Fire
1 A
larm
Rel
ay O
utpu
tN
O
CO
M
Fire
2 A
larm
Rel
ay O
utpu
t
Fau
lt R
elay
Out
put
NO
CO
M
NO
CO
M
Fire
1 A
larm
Rel
ay O
utpu
tN
O
CO
M
Fire
2 A
larm
Rel
ay O
utpu
t
Fau
lt R
elay
Out
put
NO
CO
M
NO
CO
M
DC24+
DC24-
ABRS485 Communication
DC24V Power
Mini CONVENTIONAL FIRE ALARM CONTROL PANELS
FEATURES
CABINET AND MOUNTING
Fire Alarm Panel Cabinet physical dimensions: 108 mm wide x 143 mm high x 40 mm deep.
Power Supply Cabinet dimensions:: 205 mm high x 255 mm wide x 90 mm deep.
Master Panel Cabinet net weight: 520 g.
Slave Panel Cabinet net weight: 500g.
Mounting: The cabinet mounts using two key slots at the top of the back and two additional
6.5mm diameter holes at the bottom.
CP1002M 2 Zone Master
Fire Alarm Control Panel
CP1002S 2 Zone Slave
Fire Alarm Control Panel
Model: YT102
System Voltage: 24VDC
Standby Current: 200μA max.
Alarm Current: 50mA max.
WT105
FT103
CF6002
JL188
YT142
Smoke Detector
Model:
System Voltage: 24VDC
Standby Current: 200μA max.
Alarm Current: 50mA max.
Heat Detector
Model:
System Voltage: 24VDC
Standby Current: 200μA max.
Alarm Current: 50mA max.
Smoke & Heat Detector
Model:
System Voltage: 24VDC
Standby Current: 200μA max.
Alarm Current: 50mA max.
4-Wire Smoke Detector(Relay Output)
Model: SB106
System Voltage: 24VDC
Standby Current: 50μA max.
Alarm Current: 30mA max.
Manual Call Point
Model: SG109
System Voltage: 24VDC
Sound Output: 93dB(A)
Alarm Current: 30mA max.
Sounder Strobe
Model:
System Voltage: 24VDC
Spectrum: 180-290nm
Alarm Current: 20mA max.
Strobe
Model:
System Voltage: 24VDC
Sound Output: 95dB(A)
Alarm Current: 70mA max.
Bell
Relay Contact: 2A@24V
Diameter: 150mm
One slave Panel has two zones, each zone can connect max.25 conventional detectors.
One Master Panel also has two zones, each zone can connect max.25 conventional detectors.
The Mater panel could show the fire and fault of all slave panel. The slave panel can only
show itself fire and fault.
Mini size as 108X143X40mm
Master panel has 4 digital LED display to show slave number and status.
2 Detection Zones Panel, 25 Detectors per Zone
Fire 1 relay would be activated when one zone alarms.
Fire 2 relay would be activated after 30 seconds delay when two zones alarm.
1 Sound relay output for sound alarm
1 Fault relay output for fault condition
Zones Fire and Fault LEDs indication
Fire1, Fire2, Sound relay outputs can be activated manually
RS485 Port for repeater up to 1.2Km
Up to 31 Slave panels can be connected to one Master panel
Powered by outside DC22-26V power supply
End Of Line Status Detection, Short circuit /open circuit detection
Two modules power supply could be selected.
The power supply input is AC90-270V
Two 4AH batteries can be housed in the power supply cabinet.
Relay output contacts rated at: 2.0 amps @ 30 VDC.
CP35W:24V/1.5ACP70W: 24V/3.0A
Power Supply
The mini 2 zone panel have Master panel and Slave panel. One Master panel can connect 31 Slave panel, and the Master panel could show the fire and fault of all slave panel. The slave panel can only show itself fire and fault.
Mini CONVENTIONAL FIRE ALARM CONTROL PANELS