Upload
grigorevasile5680
View
100
Download
4
Embed Size (px)
DESCRIPTION
Modalitate de conectare a comenzii de control al vitezei.
Citation preview
1
Posted 07 September 2008 - 03:49 PM
Here is how to install Cruise Control to your Auris...Found this instruction on Toyota Owner's Club Russia
-forum, special thanks to Andron, who took the pictures and wrote the russian text!
I made some improvements and posted it here, enjoy...
You're gonna need two parts:
Cable
4
After that, remove the cover caps from both sides of the wheel
After removing you will see the following:
(there is a possibility that the caps don't exist, if so, you'll see one screw on both sides of the wheel,
and should just continue to the next step)
Remove the screws (TORX 30).
Pull the airbag covers' upper side towards yourself. DO NOT disconnect the airbag's wire!
6
Put the switch to it's place from the inside of the right hole (or make the hole in case
you didn't do the "remove the covers from both sides of the wheel" -step because of
not having any covers.
After that just tighten the switch with two M5x10mm, not M6
screws
8
Under the airbag cover you'll see the connection places, the one on the right is free
Connect the wire to it
Insert the wire as it is shown on the picture below
9
After it's done just put everything back as it was...
Turn on the ignition and push the "ON/OFF" button
10
Resized to 58% (was 820 x 580) - Click image to enlarge
Everything is ready and working just fine!
Now all you need is a test drive... But please read how to use the Cruise Control
from your Toyota owner's guide!
You cannot install Cruise Control if your car has 4ZZ-FE -engine!!