crv-keyless

8/9/2019 crv-keyless

1/12

1

OPERATING INSTRUCTIONS

KEYLESS ENTRY SYSTEM

KIT NO.: 08E60-S9A-100


2/12

2

Please write the serial number of the remote control below. Keep this booklet as a

record of your purchase.

Remote Control No.: Main Unit No.:No.:

Contents

Introduction.................................................................................... 3Precautions.................................................................................... 4Remote Control Transmitter

Controls and Functions ............................................................. 6Battery Replacement ................................................................ 8

Remote Control Code ProgrammingHow to Program Remote Control Transmitters ......................... 9


3/12

3

Congratulations on your purchase of this Honda Keyless EntrySystem.Your Honda Keyless Entry System is the product of years ofresearch and development. It will give you many years of reliable

performance, protection, and convenience.

The system consists of a remote control transmitter.

The remote control allows you to operate from outside the vehiclewhile simultaneously locking and unlocking the doors. Thetransmitter can also be used to intentionally activate the horn incase of an emergency.

To take full advantage of your Honda Keyless Entry System, weencourage you to read this manual thoroughly.

Introduction

This device complies with FCC Rules Part 15. Operation issubject to the following two conditions: (1) This device may notcause harmful interference and (2) This device must accept anyinterference that may be received including interference that may

cause undesired operation.


4/12

4

Precautions

Remote Control RangeSeveral factors affect and reduceremote control range. Amongthese are:

1. Proximity to buildings andautomobiles.2. Proximity to high power

transmitters (television,radio, cellular, HAM radio,etc.).

3. When the battery becomesweak, the remote controlrange becomes short.

Vehicle construction and thesurrounding environment cause

reflected waves that mayinterfere with the low power RFsignal transmitted by the remotecontrol. This interference mayresult in "dead spots" around thevehicle; places where remotecontrol signals will not beaccepted by the main unit.

Handling RemoteControl TransmitterThe remote control transmitter isa sophisticated electronic device.To maintain optimum systemperformance, avoid mishandlingthe remote control (i.e. dropping,throwing).

TemperatureAvoid exposing the remotecontrol transmitter to extremehot or cold weather conditions.

Liquids

Never submerge the RemoteControl Transmitter in water.


5/12

5

Precautions

Battery PowerUse the remote controltransmitter only when necessary.Every time a button is pressed,the remote control is consumingbattery power.If battery is low on power, thetransmitting range of the remotecontrol will be affected. Checkbattery periodically and replace itwhen necessary.

Outside CleaningUse a soft cloth to clean the mainunit and remote control.Do not use kerosene, thinner orany other type of solvent.

In Case of LossIf one of your remote control transmitters is ever lost, contact yourlocal Honda dealer for a replacement. Your system will bereprogrammed to prevent the lost remote control transmitter fromoperating your system. In this case, take all the other remote controltransmitters to have them reprogrammed.If you own extra remotes, bring it all to the dealer for reprogramming.


6/12

6

LOCK Button

When used alone, this button locks thedoors and the tailgate, and flashes theparking lights once.

Note:If the lock button is pressed for a secondtime (within 5 seconds of the first push) thehorn will beep once and parking lights willflash once to confirm the doors and thetailgate are locked.

The doors and the tailgate cannot be locked or unlocked with the remote controltransmitter when the key is in the ignition switch.

The doors and the tailgate cannot be locked if any one of the doors or the tailgate isopen. But even if the hatch glass is opened, the doors and the tailgate can be locked.

The panic mode will not work when the ignition switch is turned ON.

UNLOCK Button

This button unlocks the door(s) and thetailgate.When this button is pressed once, only thedriver side door will unlock and the parkinglights will flash twice. Pressing the buttonagain, within 30 seconds, will unlock all thedoors and the tailgate, and flash theparking lights twice.The interior light illuminates for 30 secondswhen the interior light switch is set to thecenter position.

Note:After unlocking the door(s) and the tailgate,the system will relock (with no "beep") in 30seconds when any of the doors or thetailgate is not opened, the ignition switch isnot turned ON, the SILCON switch (LOCK)on the drivers side is not turned ON, or theremote control switch (LOCK or UNLOCK)on the drivers side is not turned ON.

Remote Control Transmitter

Controls and Functions

2

1

1

2


7/12

7


PANIC ButtonWhen this button is pressed and held formore than 1 second, the keyless entrysystem is set to the panic mode.The horn will sound for 30 seconds and theparking light and headlights will flash.To deactivate the panic mode, press the"LOCK", "UNLOCK" or "PANIC" button orturn the ignition key to the "ON" (II) position.

Signal Indicator LEDThe LED will light when a remote controlbutton is pushed and the remote control istransmitting a control signal.The LED indicates the remote controlsbattery condition. If the brightness of theLED dims, the battery should be replaced.

4

5

34

3 HATCH GLASS RELEASE BUTTONTo open the hatch glass on the tailgate, pushthe "HATCH GLASS RELEASE" button forabout two seconds.

5


8/12

8


1

2

Using a coin turn the battery cover counterclockwise and remove the cover from the back of

the remote control.

Remove the used battery. Make sure you install the new battery with the proper polarity.

Note: If the Lithium battery is incorrectly placed (+ and polarity), the Remove Control

Transmitter can be damaged.

Battery Replacement The remote control transmitter requires one lithium battery (#CR2025).

Replace the battery cover. Use a coin to turn it clockwise and lock the cover.

3


9/12

9

Remote Control Code Programming

1

2

Unlock the doors and the tailgate.

Turn the ignition key to the "ON" (II)position.

4 Turn the ignition key to the "OFF" (0, I)position.

How to Program RemoteControl Transmitters

For steps 2 through 12, each step must be completed within 5 seconds. For step 13,within 10 seconds for each remote.

Up to 3 remotes can be stored in memory. All remotes to be programmed must be on hand. A non programmed remote will work for this procedure. Turn the ignition key to the "OFF" position to complete the programming procedure.

3 Press the "LOCK" or "UNLOCK" button onthe remote control transmitter.

5 Turn the ignition key to the "ON" (II)position.

3


10/12

10



7 Turn the ignition to the "OFF" (0, I) position.

8 Turn the ignition to the "ON" (II) position.


10 Turn the ignition to the "OFF" (0, I) position.

11 Turn the ignition to the "ON" (II) position.

6 9


11/12

11


12

13

Press the "LOCK" or "UNLOCK" button onthe remote control transmitter. The power door locks cycle to indicate

programming mode. To terminate the programming mode at

this point, either turn the ignition key to

the "OFF" position or leave the remotesbutton untouched for over 10 seconds. Toprogram the remote, perform steps 2through 12.

Press the "LOCK" button of each remote(one at a line) to be stored in memory. The power door locks cycle to confirm

each entry. A button on each remote control

transmitter to be programmed must bepressed. Perform the programming stepwithin 10 seconds for each remote or elsethe programming mode will terminate.

Note:Only 3 remotes can be stored in the systemsmemory.

12

13


12/12

12

Specifications

Remote Control TransmitterTransmitter Type .............................................................................................. Radio frequencyRange .............................................................................................................Maximum 30 feetBattery Type ................................................................................................ Lithium (# CR2025)Battery Life ......................................................................................................... 1 year (typical)Operating Temperature .......................................................... 20C to +60C(4F to +140F)Dimensions..................................... 30.7 mm x 65 mm x 11.5 mm(1-3/16" x 2-9/16" x 15/32")Net Weight ............................................................................................................. 21 g (0.7 oz)

NOTE: Due to continuous product improvement, specifications and design are subject to change without notice.

American Honda Motor Co., Inc. 2001 All Rights Reserved.

08E60-S9A-1000-81Printed in Japan

Documents

crv-keyless