Embed Size (px)
Citation preview
The F-10 is used to measure currents on 50Hz, 60Hz, and 400 Hz power lines. The F-10 current probe has a transfer impedance of .25Ω from 2kHz to 2MHz. The F-10 has a usable frequency range overlapping thefundamental powerline frequencies. It can handle 350 amperes of primary power line currents from DC to 400Hz without saturation.
F-10Current Probe
Fischer Custom Communications, Inc.
F-10 Specifications Frequency: 100 Hz – 3 MHz Connector: Type-N Internal diameter: 32mm DC to 60 Hz: 350 amperes External diameter: 94mm 400 MHz: 350 amperes Height: 64mm RF(CW): 100 amperes ZtΩ1: 0.25 Pulse2: 100 amperes dBΩ1: −12 1: Probe calibrated with 50Ω+j0Ω Load Impedance 2: Depends upon the pulse width and pulse rep. Rate.
20603 Earl St., Torrance, CA 90503 · Phone: 310-303-3300 Fax 310-371-6268 · email: [email protected]
© Fischer Custom Communications, Inc. 072803DS-F-10
All rights reserved • Printed in USA
-43
-38
-33
-28
-23
-18
-13
10H z 100H z 1kH z 10kH z 100kH z 1M H z 10M H zFrequency
Tran
fer I
mpe
danc
e (d
B o
hms)
