Custom ToeOFF Custom ToeOFF & BlueRocker Achieving Success! After viewing this presentation you...
30
Custom ToeOFF Custom ToeOFF & BlueRocker Achieving Success! After viewing this presentation you should be made fully aware of the proper techniques required to fit a Custom ToeOFF or BlueRocker.
Custom ToeOFF Custom ToeOFF & BlueRocker Achieving Success! After viewing this presentation you should be made fully aware of the proper techniques required
Custom ToeOFF Custom ToeOFF & BlueRocker Achieving Success!
After viewing this presentation you should be made fully aware of
the proper techniques required to fit a Custom ToeOFF or
BlueRocker.
Slide 3
Custom ToeOFF Indications Applications Process and procedures
Model acquisition Reimbursement Agenda This presentation will
cover
Slide 4
Custom ToeOFF CVA MS CMT ALS TBI GB SCI Neuropathy Post-Polio
Soft-tissue Injuries Indications Some of the indications that have
been successfully fit with both Standard and Custom ToeOFF products
are:
Slide 5
Custom ToeOFF Applications Atrophy Obesity Deformity Modified
ToeOFF or Blue Rocker properties The primary reasons you would use
a Custom over a standard product are for the following
conditions:
Slide 6
Custom ToeOFF Some additional applications include: Change
support level AP (crouch gait) ML (Trunk sway) Change heel rise
Incorporate relief Tibial crest Cavus foot
Slide 7
Custom ToeOFF A Custom ToeOFF NOT an application for:
Delamination Refer to the ToeOFF Customization guide to resolve
delamination issues.
Slide 8
Custom ToeOFF Evaluate patientAssess in standard ToeOFF or
BlueRocker whenever possible Establishes baseline for required
dynamic response Process & Procedures
Slide 9
Custom ToeOFF Evaluate patient Complete forms Process &
Procedures
Slide 10
Custom ToeOFF Evaluate patient Complete forms Important to fill
out information on size used for evaluation purposes. Process &
Procedures
Slide 11
Custom ToeOFF Evaluate patient Complete forms Page 4 allows
changes to be made to the dynamic properties. Fill out all grey
boxes. Process & Procedures
Slide 12
Custom ToeOFF Evaluate patient Complete forms Measure the heel
height of the patients shoe to make sure the Custom ToeOFF is
aligned properly. Process & Procedures
Slide 13
Custom ToeOFF Evaluate patient Complete forms Page 5 is only to
be used when ordering by measurements. Photo must accompany the
forms. Dont forget to attach pages 3 & 4. Process &
Procedures
Slide 14
Custom ToeOFF Evaluate patient Complete forms Select footwear
Process & Procedures Shoe selection Shank & counter Rocker
sole Facilitate 3 rd rocker Measure Heel Rise
Custom ToeOFF Evaluate patient Complete forms Select footwear
Determine heel rise Manage the foot biomechanics. Process &
Procedures Foot orthotic shell At a minimum Custom if necessary
Capture if casting or scanning
Slide 17
Custom ToeOFF Evaluate patient Complete forms Select footwear
Determine heel rise Manage the foot What is possible Process &
Procedures
Slide 18
Custom ToeOFF What is possible? Modify the properties of a
Standard ToeOFF!
Slide 19
Custom ToeOFF What is possible? Extra small No height
restrictions on the low end. Smallest footplate is 190mm or 7
Process & Procedures
Slide 20
Custom ToeOFF What is possible? Extra small Extra tall Up to
taller than an XL Max. Footplate length 310mm or 12 Process &
Procedures
Slide 21
Custom ToeOFF What is possible? Extra small Extra tall Increase
or decrease stiffness by up to 2 times a standard product. AP ML
Process & Procedures
Slide 22
Custom ToeOFF Cast-requirements Fiberglass only
Posterior-medial opening Neutral in sagittal plane Or to proper
heel height Anterior & Lateral plumb lines Model
Acquisition
Slide 23
Custom ToeOFF Cast Note: If there are any uncorrectable
deformities in the frontal plane, they should be represented by
standing the patient and then marking the plumb lines. Model
Acquisition
Slide 24
Custom ToeOFF Cast Measurement All forms must be completely
filled out 4(exactly) Piece of tape, placed vertically on calf
Photo must accompany the forms Model Acquisition
Slide 25
Custom ToeOFF Cast Measurement Scan Must have extension .cxpxp
or export as a STL File Model Acquisition
Slide 26
Custom ToeOFF Two replacements within one year If on using the
left side of form Heel height from to 1 Standard lateral strut
Greater than 1, covered 6 months under GMP (Good Manufacturing
Practices) Warranty
Slide 27
Custom ToeOFF Casts shipped to Allard USA, then to Sweden 3 4
week turnaround Scans or measurements emailed to Sweden 2 3 week
turnaround Turnaround Time
Custom ToeOFF Contact Additional Information Scott Hennessy, CO
National Product Manager Office 888-678-6548 Fax 800-289-0809 Cell
210-874-1599 [email protected] www.allardusa.com