Upload
others
View
5
Download
0
Embed Size (px)
Citation preview
Technical Tip
www.Compustar.com | Tech. Support: 888-820-3690
FT-DC2-S/AS Alarm Feature Activation
With a new product comes a learning curve. While we attempted to minimize the differences between our standard brains (CM800-S, CM600-AS, CM7x00, etc.), there are some important differences to note. When attempting to use the DC2 as a full remote start with security, whether it’s the DC2S or DC2AS the alarm feature is OFF by default. This will give you a
step by step walk through to enable the alarm feature.
a. Select the Vehicle the DC2 is Getting Installed Into
For demonstration purposes we’ve already selected a vehicle. Once you’ve selected the vehicle it will show you the firmware the control module will be flashed to. Before hitting “FLASH!” you’ll want to select “CONFIGURE FEATURES.”
Technical Tip
www.Compustar.com | Tech. Support: 888-820-3690
b. Select Menu #3 – “Security” You’ll be presented with 8 menus in which to control different features of the DC2. Menu #3, labeled “Security” is where
we will need to be to enable the alarm features.
Technical Tip
www.Compustar.com | Tech. Support: 888-820-3690
c. Select the Alarm Feature & Turn it On
Technical Tip
www.Compustar.com | Tech. Support: 888-820-3690
d. Click “SAVE / FLASH”
Technical Tip
www.Compustar.com | Tech. Support: 888-820-3690
e. Installation Notes
The Brown / Black Dot wire on the M2 connector (Black 12 pin connector, pin 7) is your siren output.
The Red 4-pin connector at the end of the DC2 (near LED 2) is for the FT-DAS sensor.
The dial, next to the Red 4-pin FT-DAS port is for the FT-DAS sensitivity with settings OFF to 10. 1 is the LEAST sensitive, 10 is the MOST sensitive - - this is opposite when compared to the FT-7S and FT-7AS controllers.