112 112 112"
Distance from Wall to edge of Gate Post minimum
Distance from Wall to edge ofGate Post minimum
96"
Ref only 30"
Spacing equalWill place posts before fabrication of gates
sectionsGates to be fab after field verification
Distance fromWall to edge of
Gate Postminimum
Distance from Wall to edge of Gate Post minimum
Spacing equalWill place posts before fabrication of gates
sectionsGates to be fab after field verification
6" post welded to 12x12 x1/2 plate ( Alternate - Plate mount sim
to Bollards)
Self closing hinges
Latch and drop pegs
Bldg Wall
6" sq tube alum post
3" sq tube frame surround
Nom 3"x 5" louver blade with over lap to screen dumpster
2" to 4" clearance
General Notes1. Construction:
Pickets are welded to top and bottom rail members and snap
cover. Top &Bottom rail members welded to Vertical frame-
Louver blades weld to vertical members. MIG Weld 4043 weld wire
2. Finish: Acid Cleaner (Oakite CrysCoat 2147)-Rinse - Gardolene
D 6871 -TGIC Polyester Powder unless upgraded. After powdering,
material will be protected with Plastic sheet applied to
surface.
3. Installation: All cuts, hardware and anchor bolts must be
touched up by installers not to void warranty/gaurantee. All
penetrations of powder coating must be touched up by installers
prior to completion of installations. General Contractor before
receiving warranty will confirm that all gates have been touched up
either by installers or GC punchout staff.
4. Maintainence:Although powder coating is extremely durable,
cosmetic damage may occur through handling, installation or other
environmental concerns during construction and after. Most problems
can be fixed with detergent and water. Mild distallates such as
acetone, kerosine, gasoline and most water base thinners can be
used to clean stubborn stains. Use paint strippers or MEK only as a
last resort. Short exposure should not harm the finish. Avoid
abrasives, use of which will damage the finish by reducing the
thickness or eliminating it completely. Touch up paint should (of
the lacquer or acrylic enamel variety) adequately adhere to the
finish. All scratches, abrasions and hardware items must be touched
up with paint. Failure can void any warranty on finish. Note: All
strong acids or bases such as CLR™, Concrete cleaners, Ice Melts
will damage the railing and coating if not removed immediately. All
screws, nuts and bolts should be inspected during any scheduled
maintanence review.
5. Materials:Unless otherwise specifield, all structural members
are 6061/6005/6105 high strength alloys. Non structural members
6063. Tempers T5Fastners are SS Rivets or Stainless Steel
self-tapping Teks™ screwsAll other materials that are provided for
or used with this product will be corrosion resistent non galvanic
reaction materialsWhen product is in contact with masonry, a
minimum of 1 mm of plastic(powder coat), or other material shall be
used.
Special Note:Each leaf aapox 150#
End Post
4 Expansion Bolts 1/2 Diameter x 5" embedment
3-1/2" from Concrete Edge
7 1/2"12"
10"1"
Mid Post
12"
1"10
"
6" sq
5"
Recommended Hardware1/2" diameter by 6" Wedge bolt or equal
