4
DM-216 Date of issue : 28-Oct-2013 Ref.No. : 0353-4E 1 Flammable liquids, Acute toxic substances 50 78-93-3 C4H8O 111-15-9 C6H12O3 C8H10 4 40 Methyl ethyl ketone CAS No. Chemical formulae 110-49-6 1 Remove all contamination with clothes and wash the affected area with water and soap. If irritation persists, or abnormal conditions are found, arrange examination and treatment by a physician. 10 1 108-67-8 Molybdenum Disulfide 1317-33-5 ENVIRONMENTAL EFFECTS No relevant information found. 3. HAZARDS IDENTIFICATION CLASS NAME OF HAZARDOUS CHEMICALS FOR SDS IN JAPAN : SKIN CONTACT EYE CONTACT Gently rinse the affected eyes with clean water for at least 15 minutes. And refer for medical attention. 4. FIRST-AID MEASURES Cyclohexanone 108-94-1 C6H10O 4 25 35 3-Methoxybutyl acetate 4435-53-4 C7H14O3 Ethylene glycol monomethyl ether acetate C5H10O3 C9H12 Name of Section: Address: QUALITY ASSURANCE DEPT. 639, KOUSYU, GOKA-MACHI, SASHIMA-GUN, IBARAKI, 306-0304, JAPAN Phone: Fax: +81-280-80-1577 +81-280-84-2620 2. COMPOSITION / INFORMATION ON INGREDIENTS Vapors may catch fire and explode. PHYSICAL AND CHEMICAL HAZARD Xylene 1330-20-7 C8H10 1 Ethyl benzene 100-41-4 ADVERSE HUMAN HEATH EFFECTS SUBSTANCE / MIXTURE: Mixture INGREDIENTS AND COMPOSITION: Ethylene glycol monoethyl ether acetate Harmful by inhalation and in contact with skin. C9H12 4 MATERIAL SAFETY DATA SHEET 1. CHEMICAL PRODUCT & COMPANY IDENTIFICATION Chemical Product Name: Name of Manufacture / Supplier: Solid film lubricant NICHIMOLY DIVISION, DAIZO CORPORATION Product Name: DM-216 1,3,5-trimethyl-benzen 30 1 Epoxy resin Confidential Unspecified 5 15 Cumene 98-92-8 20 MoS2 Mass % COMPOSITION 5 1 15 page 1/4

Dm 216英文msds

Embed Size (px)

DESCRIPTION

MSDS

Citation preview

Page 1: Dm 216英文msds

DM-216 Date of issue : 28-Oct-2013

Ref.No. : 0353-4E

1

Flammable liquids, Acute toxic substances

5078-93-3 C4H8O111-15-9 C6H12O3

C8H10

4

40 ~Methyl ethyl ketone

CAS No. Chemical formulae

110-49-61

Remove all contamination with clothes and wash the affected area withwater and soap. If irritation persists, or abnormal conditions are found,arrange examination and treatment by a physician.

~ 10

1 ~

108-67-8

Molybdenum Disulfide 1317-33-5

ENVIRONMENTAL EFFECTS No relevant information found.

3. HAZARDS IDENTIFICATIONCLASS NAME OF HAZARDOUS CHEMICALS FOR SDS IN JAPAN :

SKIN CONTACT

EYE CONTACT Gently rinse the affected eyes with clean water for at least 15 minutes. Andrefer for medical attention.

4. FIRST-AID MEASURES

Cyclohexanone 108-94-1 C6H10O4

25 ~ 353-Methoxybutyl acetate 4435-53-4 C7H14O3

Ethylene glycol monomethyl ether acetate C5H10O3

C9H12

Name of Section:Address:

QUALITY ASSURANCE DEPT.639, KOUSYU, GOKA-MACHI, SASHIMA-GUN, IBARAKI,306-0304, JAPAN

Phone:Fax:

+81-280-80-1577+81-280-84-2620

2. COMPOSITION / INFORMATION ON INGREDIENTS

Vapors may catch fire and explode.PHYSICAL AND CHEMICAL HAZARD

Xylene 1330-20-7 C8H10 1Ethyl benzene 100-41-4

ADVERSE HUMAN HEATH EFFECTS

SUBSTANCE / MIXTURE: MixtureINGREDIENTS AND COMPOSITION:

Ethylene glycol monoethyl ether acetate

Harmful by inhalation and in contact with skin.

C9H12

~ 4

MATERIAL SAFETY DATA SHEET

1. CHEMICAL PRODUCT & COMPANY IDENTIFICATION

Chemical Product Name:Name of Manufacture / Supplier:

Solid film lubricantNICHIMOLY DIVISION, DAIZO CORPORATION

Product Name: DM-216

1,3,5-trimethyl-benzen

30

1Epoxy resin Confidential Unspecified 5 ~ 15Cumene 98-92-8 <

20 ~MoS2

Mass %COMPOSITION

5

1

15~

page 1/4

Page 2: Dm 216英文msds

DM-216 Date of issue : 28-Oct-2013

Ref.No. : 0353-4E

Follow all regulation in your country.

4.

Water may be effective for cooling.5.

Prevent spills from entering sewers, watercourses.

Avoid contact with personnel.Pay caution for ventilation and ignition.Wear proper protective equipment for prevention of skin, or eye contact.

5.

6.

Consumption of non-oily liquids (such as milk) may assist in delayingabsorption of the liquid.Arrange examination and treatment by a physician as soon as possible.

In case of small fire, use dry chemical powder or carbon dioxide.2.

In case of large inhalation, remove the victim from the contamination tofresh air. Keep the victims warm and quiet. If breathing is weak, irregular orhas stopped, administer artificial respiration.Arrange examination and treatment by a physician as soon as possible. Incase of vapor, gas, remove the victim from the contamination to fresh airand arrange examination and treatment by a physician as soon as possible.

INGESTION

1. Shut off fuel to fire.

Rinse mouth with water and dilute with water. Do not induce vomiting asthis may increase the risk of aspiration of the liquid into the lungs causingchemical pneumonitis.

1. Keep away from flame, fire, or other heat.2.3.

Pay caution for ventilation and source of ignition, because evaporation is heavier than air andtrends to contaminate.

Wear proper protective equipmentPrevent spreads by sand, etc. and lead spill to safe zone and take up and place in containeras much as possible.

●For the case of small release:Absorb spill with sand, clothes and then place in waste containers and completely removedcontamination by clothes.

7. HANDLING & STORAGEHANDLING:

2. Prepare proper fire-extinguishing measures.●For the case of large release:

Evacuate non essential personnel

1. Shut off all sources of ignition.

EXTINGUISHING MEDIA:Dry chemical powder, form of carbon dioxide.

6. ACCIDENTAL RELEASE MEASURES

8. Evacuate personnel to safe area.SPECIAL HAZARDS WITH REGARDS TO FIRE-FIGHTING MEASURES:

Toxic gases (carbon monoxide) will foam upon combustion. Pay attention to burst of containerdue to heat.

6. Keep personnel removed from and upwind fire.7. Firefighters should were proper protective equipment.

3. In case of large fire, form spray is effective to stop flow-in of air.4. Watering may enlarge fire and increase risks.

5. FIRE-FIGHTING MEASURES

INHALATION

page 2/4

Page 3: Dm 216英文msds

DM-216 Date of issue : 28-Oct-2013

Ref.No. : 0353-4E

8. EXPOSURE CONTROL / PERSONAL PROTECTIONCONTROL PARAMETER:

ENGINEERING MEASURES:

Methyl ethyl ketoneEthylene glycol monoethyl ether acetate

Xylene

TLV-TWACOMPOSITIONppm200

4. Keep away from sunlight.

1. Store in cool, dry, well-ventilated location.2.

SELF-REACTIVITY: Will not occurSTABILITY & REACTIVITY: This material is stable. Hazardous decomposition

and polymerization will not occur.

Will not occurREACTIVITY WITH WATER:

AUTO IGNITION TEMPERATURE:

SOLUBILITY IN WATER: Miscible

No relevant information found.10. PHYSICAL HAZARDS (STABILITY & REACTIVITY)

2. Make available in work area emergency shower, hand wash, eye wash and clearly indicate thelocation thereof.

SOLUBILITY IN ORGANIC SOLVENT: Insoluble

Wear electric-conductibility boots.

-9℃DENSITY: 1.05 g/cm3 @25℃

PERSONAL PROTECTIVE EQUIPMENT:

Keep at temperature below 40℃

STORAGE:

5.6.

Keep away from heat and all possible source of ignition.3. Keep away from reach of child.

RESPIRATORY PROTECTION

1.

For prolonged works or use of large quantity, wearchemical cartridge respirator (with an organicvapor cartridge).

ODOR: Aromatic odor

For prolong works inside, provide ventilation equipment or close the source of ignition.For use of large quantity outside, electric equipment shall be of explore-proof and earthed.

EYE PROTECTION Wear safety glasses.PROTECTIVE WEAR Wear long-sleeve working wear.

UPPER AND LOWER EXPLOSION LIMIT: No relevant information found.

SPONTANEOUS COMBUSTIBILITY: Will not occurFLAMMABILITY:

OTHERS

BOILING POINT: 80℃~

PHYSICAL STATE, FORM: LiquidCOLOR: Black

FLASH POINT:

9. PHYSICAL & CHEMICAL PROPERTIES

Flammable

StableOXIDIZIBILITY:

ppm

Cyclohexanone

Ethyl benzene1,3,5-trimethyl-benzen 25

10050

ppmppmppmppm

520

Follow all regulation in your country.

page 3/4

Page 4: Dm 216英文msds

DM-216 Date of issue : 28-Oct-2013

Ref.No. : 0353-4E

3

13. DISPOSAL CONSIDERATION

EFFECTS ON THE REPRODUCTIVE SYSTEM: No relevant information found.TERATOGENIC EFFECTS:

12. ECOLOGICAL INFORMATION

Packing Group : Ⅱ

Class

1263

Flammable Liquids

Paint or paint related material

CARCINOGENIC EFFECTS:CHRONIC TOXICITY: No relevant information found.

UN Class. :

UN No. :

1.2. Do not dump into sewers , on the ground or into any body of water.

14. TRANSPORT INFORMATION

3. Disposal shall be in accordance with the concerned rules and regulation.

ALLERGENIC AND SENSITIZING EFFECTS: No relevant information found.CORROSIVELY AND IRRITANT PROPERTIES No relevant information found.

11. TOXICOLOGICAL INFORMATION

BIOACCUMULATION: No relevant information found.

16. OTHER INFORMATIONAll materials may present unknown hazard and should be used in caution. Although certainhazards are described herein, we cannot guarantee that these are the only hazards which exist.

Follow all regulation in your country.

Follow all regulation in your country.

4. Follow all regulation in your country.

Do not throw the container into fire.

15. REGULATORY INFORMATION

MUTAGENIC EFFECTS: No relevant information found.

FISH TOXICITY: No relevant information found.

No relevant information found.

BIODEGRADABILITY: This substance is not biodegradable.

No relevant information found.

3-Methoxybutyl acetate 4,210 mg/kgXylene 4,300Ethyl benzene

5,100

4,300 mg/kg

ACUTE TOXICITY:

mg/kg

mg/kg

Cyclohexanone 1,620

mg/kgEthylene glycol monoethyl ether acetate mg/kg

COMPOSITION Oral Rat LD50

Methyl ethyl ketone 2,737

page 4/4