Upload
roger-cross
View
216
Download
0
Embed Size (px)
Citation preview
Electrical StimulationElectrical StimulationBasic Setup and Patient Basic Setup and Patient PreparationPreparation
Read and Follow the Manufacturer’s Read and Follow the Manufacturer’s RecommendationsRecommendations
The ProcessThe Process
Preparation of the GeneratorPreparation of the Generator Electrode PreparationElectrode Preparation Patient PreparationPatient Preparation Termination of the TreatmentTermination of the Treatment MaintenanceMaintenance
Preparation of the GeneratorPreparation of the Generator
Power SupplyPower Supply Battery operated: Assure batteries are fully chargedBattery operated: Assure batteries are fully charged Clinical: Plugged into a GFCIClinical: Plugged into a GFCI
Do not use extension cordsDo not use extension cords LeadsLeads
Check for tangles, frays, and loose jacksCheck for tangles, frays, and loose jacks Replace if insulation is wornReplace if insulation is worn Repair loose jacksRepair loose jacks
PowerPower Make sure power is offMake sure power is off Reset output intensity to ZERO Reset output intensity to ZERO
Preparation of the ElectrodesPreparation of the Electrodes
Reusable ElectrodesReusable Electrodes Clean to remove residual gel and skin oilClean to remove residual gel and skin oil Use alcohol or other approved cleaning agentUse alcohol or other approved cleaning agent Most carbon-impregnated electrodes require a wet Most carbon-impregnated electrodes require a wet
mediummedium If conducting sponges are used, moisten with waterIf conducting sponges are used, moisten with water
Self-adhesiveSelf-adhesive Clean with soap and waterClean with soap and water Follow manufacturer’s recommendationsFollow manufacturer’s recommendations
Connect the electrodes to the leadsConnect the electrodes to the leads
Patient PreparationPatient Preparation
Rule out contraindications to the treatmentRule out contraindications to the treatment Determine appropriate electrode placementDetermine appropriate electrode placement Clean the treatment areaClean the treatment area Apply and secure the electrodesApply and secure the electrodes Explain the sensations to be experienced Explain the sensations to be experienced
during the treatmentduring the treatment If applicable, give the patient a safety switchIf applicable, give the patient a safety switch Monitor the patient during the treatmentMonitor the patient during the treatment
Termination of the Termination of the TreatmentTreatment
If the unit does not automatically power down:If the unit does not automatically power down: Reduce the output intensity to ZERO and/or press Reduce the output intensity to ZERO and/or press
the STOP buttonthe STOP button
Remove the electrodesRemove the electrodes Wipe the treatment area cleanWipe the treatment area clean Check the treatment area for burns or irritationCheck the treatment area for burns or irritation Interview the patient to determine effectiveness Interview the patient to determine effectiveness
of the treatment usedof the treatment used
MaintenanceMaintenance
Daily MaintenanceDaily Maintenance Clean exterior of the unit using an approved cleanserClean exterior of the unit using an approved cleanser Keep power cords and leads neatly storedKeep power cords and leads neatly storedMonthly MaintenanceMonthly Maintenance Check leads for frays or cut/torn insulationCheck leads for frays or cut/torn insulation Check for tight-fitting jacksCheck for tight-fitting jacks Check power cord for frays, cuts, etcCheck power cord for frays, cuts, etcAnnual MaintenanceAnnual Maintenance Inspection and recalibration by an authorized Inspection and recalibration by an authorized
techniciantechnician