Upload
others
View
36
Download
0
Embed Size (px)
Citation preview
www.enteq.com
Enteq MWD SystemThe complete solution for directional drilling operations
The Enteq MWD System offers a complete MWD solution with all the required components to start and sustain operations at the well-site. The combination of Enteq Drilling XXT and third party technology gives the security of very significant operational experience, high reliability and options for the best in class control and data analysis.
Advantages• Improved control and flexible management
of down-hole sensors
• Intelligent power management for maximum battery life
• Real-time and recorded shock and vibration data
• High quality data transmission and self correction to optimise drilling speed capability
• Ruggedised packaging, field proven to 175°C
• Optimised data management to exploit pulser bandwidth
• Feature rich acquisition software allowing full control of all aspects of the operation
Features• XXT Downhole electronics, drivers and
communication
• XXT and Laversab receiver card, software and surface equipment
• Industry standard or XXT pulser system
• Industry standard Gamma tool and interface
• XXT / JAE directional sensors
• Battery modules Option of easy access kit box
• Test, assembly and running gear
• Field proven resistivity tool
Delivering technologies that allow the reach and recovery of hydrocarbons
Spearpoint
Vibmon
DirectionalInterface
Module
Directional SensorModule
Pulser Helix& Lower End
Assembly
Muleshoe Assembly
PulserDriver
VibmonThe VIBMON monitors downhole shock and vibration in three axes. Real-time telemetry and display of downhole shock and vibration enables drillers to avoid costly downhole equipment failure and optimize ROP. Data is also recorded downhole for plotting and analysis on surface.
Directional Interface ModuleThe XXT DIM provides a flexible, intelligent solution for the acquisition, formatting and telemetry of downhole data to surface. It is a drop-in downhole Directional Interface Module providing Mud Pulse Telemetry compatible with industry standard Tensor systems.
Directional Sensor ModuleThe XXT-DS Directional Sensor, designed to XXT standards and specifications, incorporates the industry renowned JAE accelerometers and magnetometers. Incorporating XXT’s Digital Head module, the complete Directional Sensor assembly provides a temperature corrected plug-and-play solution using the most reliable aviation specification components.
Pulser Driver & DC Drive PulserThe XXT-PDEM Pulser Driver and DC Drive Pulser is a rugged field proven unit with a highly efficient and reliable brushless DC motor. The intelligent PDEM electronics optimizes telemetry rates and manages power consumption using an accelerometer flow switch. The DC motor drive gives huge battery savings and higher MTBF than comparable solenoid based units whilst being easy to service.
AccessoriesEnteq manufactures a complete range of MWD and DD accessories including everything needed to run an MWD survey. Our South Houston product centre makes everything from spearpoints to mule shoes and all of the barrels and interconnects in between. We also supply larger accessories including the kit boxes, tools racks and pipe screens.
OptionsGamma Ray Sensor
An Industry standard, natural Gamma Ray tool based around a highly ruggedized scintillation counter and photomultiplier tube. The GR data can be used in depth correlation and geostreering applications where radioactive uranium is associated with gas rich shales.
EM System
The Enteq EM telemetry system provides high-speed electromagnetic uphole data transmission. The systems can be used standalone in shallow wells or where mud pulse telemetry is not appropriate. It can also be ran in combination with a pulser to provide added data security and increase real-time data bandwidth.
Resistivity Tool
Single and Multifrequency LWD tools available in a complete range of sizes including slim hole. These field proven tools deliver true reservoir saturation data from multiple depths of investigation. The wireline log quality output has been used by many major oil all over the world. The data can also be used for geostreering applications.
Enteq MWD System
The Enteq surface system is based around the xxMWD/PC program suite. This PC based solution offers a unique, feature rich range of programs and utilities to cover every MWD option. Advanced capabilities such as Dynamic Sequencing save operating time and optimize data throughput. The software runs on a ruggedized Laversab 4100 unit, which is fully rated to Class 1 DIv 2 specification. Within the 4100 enclosure sits the Enteq MPRx which utilizes XXT’s best-in-class decoding algorithms to receive and decode the telemetry pulses received from the standpipe’s pressure transmitter.. Robust hardware, filtering, and embedded firmware is used to remove mud pump and other undesirable noise, allowing the XXT downhole sensors to transmit data at maximum bit rates.
System Specifications
Parameters DC Motor
Battery Life @ 1.5 DR = 700 hours
Average Power 1.04 watts
Push-pull Force ≈ 150 lbs
Longevity ≈ 3000 ihours
Holding force Very high
EM Interference Low
Service Time 2 Hours
Operating Temperature 175°C
MTBF > 2000 hours
Parameters Resolution Speed updated Data resolution, SP = ROP
Gamma Ray real Time
1.4 CPS per API
Average 18 seconds (with Dynamic Sequence enabled and 1 sec Pulse Width)
3" @ 50 Ft/HR ROP 6" @ 100 Ft/HR ROP 9" @ 150 Ft/HR ROP
Gamma Ray Recording Devise, Standard
1.4 CPS per API
Adjustible in the DIM however DIM has limited Mem
Gamma Ray Recording Devise, High Capacity
1.4 CPS per API
Adjustible in the DIM however DIM has limited Mem
Accuracy: +/- 2% to 300°, +/- 5% to 350°
Vertical resolution -gamma ray sensor: 6.8"
Operating Temperature: Up to 175°c
Shock: Z Axis 500 g/0.5 milliseconds
Vibration: 20 g RMS
Specifications
Operating Power: 90-260 VAC, 47-63 Hz, 250 VA
Operating Temperature: -40°C0 to 50°C
Storage Temperature: -40°C to 75°C
Operating / Non-operating shock: 3G RMS, 5 to 500 Hz
Humidity: 5% to 100%
Sealing: NEMA-4 on all six sides
Weight: 25 lbs
Dimensions: 16.2” (w) x 14.8” (h) x 4.45” (d)
Certification: UL 1604 / CSA C22.2 No. 213, Class 1 Div 2 location Groups A, B, C, & D; Temp. code T6 at 50°C ambient
Gamma Ray Sensor
Pulser*
Enteq Surface System
Directional Sensor Specifications*
Model 4100
Parameters Accuracy Repeatability Resolution
Azimuth (Degrees) +/- 0,5 +/- 0,5 0.1
Inclination (Degrees) +/- 0,05 +/- 0,05 0.1
Operating Temperature (°C) +/- 2,0 +/- 1,0 0.1
Local Magnetic Field (Total Magnetic Field, microTeslas)
+/- 0,1 μT +/- 0,1 μT 0,05μT
Gravitational position - front of the unit (Highside Toolface, Degrees)
+/- 0,5 +/- 0,5 0.1
Magnetic position - front of the unit [Magnetic Toolface, Degrees]
+/- 1,0 +/- 1,0 0.1
Azimuth position - front of the unit (Magnetic Toolface referenced to Grid or True North, Degrees)
+/- 1,0 +/- 1,0 0.1
Transmission resolution: Selectable
Speed (Data Rate): 0.625 bits/sec nominal
*calculated data only
*motor specs.
Downhole Tools QTY
XXT Directional Module 177°C 2
XXT Positive Pulse Pulser 177°C 2
XXT VIBMON 177°C 2
XXT Gamma 177°C 2
Lower End Assembly 2
Spear Point 2
Interconnects 12
XXT Battery Assemblies 4
Surface Equipment QTY
Aluminum Kit Box 1
Laversab RFD 2
MWD Computer with XXT Software 2
Printer w/ Printer Cable 1
Battery Test Box 1
UPS 1
Line Conditioner 1
Pelican Cases for Printer & Laptops 3
Depth System 2
Gamma Surface Equipment QTY
Software, Digidrill key 1
Null Modem Cable 2
Serial to USB Cable 2
Serial Cable 2
USB Printer Cable 1
UPS 1
Line Conditioner 1
Pelican Cases for Printer & Laptops 4
UBHO Sub QTY
8” UBHO Non Mag 6 5/8” Reg Connection 2
6 3/4” UBHO Non Mag 4 1/2” IF Connection 2
6 3/4” UBHO Non Mag 4 1/2” XH Connection 2
4 3/4” UBHO Non Mag 3 1/2” IF Connection 2
Kit Box also Contains QTY
All Handling tools needed 1
All Hand tools needed 1
Spare parts for kit 1
Consumables for kit 1
Pipe Screen QTY
Assorted sizes IF Pipe Screens 8
Wireline Equipment QTY
Swivel w/ 0.092” Fishing Neck 1
Spacer Bar - Aluminum 5’ 1
Weight Bar - Brass 5’ 1
Overshot - Bulldog or Kuster 1
Overshot - On/Off 1
J-Latch Assembly 1
Crossover - 5/8” Sucker Rod P x 1 1/4” 8-Rnd. B
1
Crossover - 5/8” Sucker Rod B x 1 1/4” 8-Rnd. P
1
Spang Jar 1
Spearpoint - Solid for Gyro 1
Muleshoe Sleeve QTY
3 1/2” (Small) 2
4 3/4” (Medium) 2
6 1/2” (Large) 2
Kit Box Contents
www.enteq.com | +1 (713) 389 5650 | Hanna Road, Oak Ridge North, Texas 77385
Headquarters
Enteq Upstream plc St Mary’s Court The Broadway Amersham Bucks, UK HP7 0UT
Enteq Upstream USA Inc. 7600 Burnet Road Suite 110 Austin Texas, USA 78704
MWD Sales
Enteq Drilling 26797 Hanna Rd. Building 2, Unit 6 Oak Ridge North, Texas, USA 77385
Main Phone: +1 (713) 389 5650 Main Fax: +1 (713) 389 5662
Sales: [email protected] Technical Support: [email protected]
Suggestions and questions: [email protected]
Enteq Drilling Products Sales
Enteq Drilling 9302-A Lambright Rd. Houston Texas, USA 77075
Main Phone: +1 (713) 944 6130
Sales: [email protected] Support: [email protected]