Equipment Nozzle Locations

7/28/2019 Equipment Nozzle Locations

http://slidepdf.com/reader/full/equipment-nozzle-locations 1/24

O:\WINWORD\3DG\P22\002-00.DOC PAGE 1 OF1

BECHTELPLANT DESIGN & PIPING

ENGINEERING DESIGN GUIDE FOR

EQUIPMENT NOZZLE LOCATIONS3DG P22 002, Rev. 00, 08/92Prepared by: Bob TarrApproved by: E.F. Bausbacher

TABLE OF CONTENTS

Page No.

LIST OF FIGURES 2

LIST OF EQUIPMENT 3

1.0 PURPOSE 4




LIST OF FIGURES

Figure 1 Centrifugal Pump - Electric Motor

Figure 2 Centrifugal Pump - Turbine Drive

Figure 3 Shell and Tube Exchanger

Figure 4 Shell and Tube Exchanger

Figure 5 Shell and Tube Nozzle Arrangements

Figure 6 Shell and Tube - Kettle Type, Nozzle Arrangements

Figure 7 Shell and Tube - Vertical Reboiler

Figure 8 Double Pipe ExchangerFigure 9 Air Cooled Heat Exchanger

Figure 10 Horizontal Drum

Figure 11 Vertical Reactor - High Pressure

Figure 12 Spherical Reactor

Figure 13 Horizontal Reactor

Figure 14 Fractionation Tower - Internal Details

Figure 15 Fractionation Tower - Typical Orientation

Figure 16 Vessels - Motor/Agitator

Figure 17 Furnace - Box Type

Figure 18 Furnace - Cylindrical

Figure 19 Reciprocating compressors

Figure 20 Centrifugal Compressors - Horizontal/Vertical Split Case

Figure 21 Centrifugal Compressors - Steam Turbine




LIST OF EQUIPMENT

Page No.

2.1.1 Centrifugal Pump - Motor Drive 5

2.1.2 Centrifugal Pump - Turbine Drive 6

2.1.3 Shell and Tube Exchangers 7

2.1.4 Shell and Tube Exchangers 8

2.1.5 Kettle Type Exchangers 9

2.1.6 Shell and Tube - Vertical Reboiler 10

2.1.7 Double Pipe Exchangers 11

2.1.8 Air Cooled Heat Exchanger 12

2.1.9 Horizontal Drum 13

2.1.10 Vertical Reactor - High Pressure 14

2.1.11 Reactor - Spherical - Horizontal 15

2.1.12 Fractionation Towers 16

2.1.13 Fractionation Towers 172.1.14 Fractionation Towers 18

2.1.15 Vessels - Motor/Agitator 19

2.1.16 Furnace - Box Type 20

2.1.17 Furnace - Cylindrical 21

2.1.18 Reciprocating Compressors 22

2.1.19 Centrifugal Compressors 23

2.1.20 Centrifugal Compressors - Steam Turbine 24




1.0 PURPOSE

This design guide is intended to highlight criteria to be considered whenestablishing equipment nozzle locations. Where options do exist, the piping

designer must make the final decision based upon the circumstances athand. This guide is not intended to address normal piping issues as theyare to be covered in the respective guides for each equipment item.




























































Documents

Equipment Nozzle Locations