Embed Size (px)
Citation preview
Equipment Setup
GCS300 – GCS900Components
Presented By:
Grade Control Systems Common Platform
• The GCS product family is built on a common architecture / platform CAN based communications Common harnesses Common sensors Common components Common hydraulic valves
Power module Valve module
Harness
Grade Control Systems Product Line Levels
• Two distinct functionality levels Each with a different operator interface
• ConventionalSlope sensorsAngle sensorsSonic tracersLaser receivers
• 3DSlope SensorsAngle SensorsSonic TracersLaser ReceiversATS TargetsGPS+GLONASS ReceiversLaser Augmentation
TrimbleCB410
Trimble CB420
Trimble CB430
Power module Valve module
Trimble GCS300: Conventional Dozer – Elevation or Blade-slope
Harness
Trimble CB420
or
Laser Slope
or
Power module Valve module
Trimble GCS400: Conventional Dozer – Elevation & Blade-slope
Harness
Trimble CB420
or
Dual Laser Laser & Slope
or
Mainfall sensor
Blade-Slope sensor
Rotation sensor
Power module Valve module
Trimble GCS500: Conventional Grader - Cross-slope only
Harness
Trimble CB420
Power module Valve module
Trimble GCS900:Elevation & Blade-slope
Harness
Laser & Slope
oror
Dual LaserTrimble CB430 Light bars
Blade-slope sensor
Power module Valve module
Trimble GCS900: 3DATS & Blade-slope
Harness
Trimble CB430 ATS Target RadioLight bars
Mainfall sensor
Rotation sensor
Mainfall sensor
Blade-slopesensor
Rotation sensor
Power module Valve module
Trimble GCS900: 3DGPS & Cross-slope
Harness
Trimble CB430 GPS+GLONASS RadioLightbars
Sonic
(opt)
Power module Valve module
Trimble GCS900: 3DDozer - Dual GPS
Harness
Trimble CB430Dual GPS
+GLONASS RadioLight bars
Trimble GCS600: Conventional Excavator – Depth & Slope
Trimble CB410
Harness
BoomAS450
BucketAS450
StickAS450
LC450 (opt)
Tilt-bucketAS450
(optional)
PlatformAS460
VA BoomAS450
(optional)
Laser (opt)
(Replaces stick sensor)
Trimble GCS900: 3DExcavator - Dual GPS
Trimble CB430Dual GPS
+GLONASS RadioLight bars
Harness
BoomAS450
BucketAS450
StickAS450
Tilt-bucketAS450
(optional)
PlatformAS460
Do’s and Don’ts
Measure Up
What’s involved??
• Measure Up Tools• Machine Settings• Machine Dimensions
– Blade Height– Blade Width between Tips– Machine Body Dimensions
• Mast Measurements– In from Blade Tip– Back from Cutting Edge Bolts– Above Cutting Edge Bolts
Why is it important??
• Measurements are from Receiver • Measurements are Machine specific• Allows for Proper Tip Measurements
– Correct Grade – Correct Location
Blade Wear
Blade Wear
• Why it Important??– Affects the Measure Up– Grade Accuracy of Machine
• What is Blade Wear??– Cutting edge of blade being worn down
• When Should it be Measured??– Dependent on material – Minimum - 1 month– Max - As the operator deems necessary
• How do I measure it??
