2-way passive speaker 200 Wpmpo set / SPK-860BLV0.0 / 0316v
This Steren product is warranted under normal usage against
defects in workmanship and materials to the original purchaser for
one year from the date of purchase.
CONDITIONS1. This warranty card with all the required
information, invoice or purchase ticket, product box or package,
and product, must be presented when warranty service is required.2.
If the product is in the warranty time, the company will repair it
free of charge.3. The repairing time will not exceed 30 natural
days, from the day the claim was received.4. Steren sell parts,
components, consumables and accessories to customer, as well as
warranty service, at any of the addresses mentioned later.
THIS WARRANTY IS VOID IN THE NEXT CASES:If the product has been
damaged by an accident, acts of God, mishandling, leaky batteries,
failure to follow enclosed instructions, improper repair by
unauthorizedpersonnel, improper safe keeping, among others.a) The
consumer can also claim the warranty service in the purchase
establishment.b) If you lose the warranty card, we can reissue it,
if you show the invoice or purchase ticket.
RETAILER INFORMATIONName of the retailer
____________________________________Address
_____________________________________________Product
______________________________________________Brand
_______________________________________________Serial number
_________________________________________Date of delivery
_______________________________________
Product: 2-way passive speaker 200 Wpmpo set Number part:
SPK-860BLBrand: Steren
IMPORTANT• Don't place the speakers outdoor.
• Do not use or store the equipment near wet places. May cause
malfunction or shock hazard.
• Don't place the speakers near to a TV or monitor, may cause
interference in the sound.
• Make sure the volume control of your audio system is in
minimum level before using the speakers. Extreme sounds may cause
damages to your ears.
INSTRUCTIONSINSTALLATIONSelect a place to install the speakers.
We recommend that are over a solid surface (a wall, under a ceiling
or marquee).
1
2
Make a drill marks.
3
Remove the support from the speaker.
Loose the screws with an allen wrench
4
SPECIFICATIONS
Place the support into the speaker again.
5 Make drills and insert the anchors (not included). Place the
speaker and screw it a little, the screws must be slightly out.
6 To make the connections, insert the wires into the correct
connectors.
Red = positive Black = negative
Adjust the position of the speaker and tighten the screws when
the angle is right.
Woofer: 76 mm (3")Tweeter: 19 mm (0.75")Power output: 200 WPMPO,
15 Wrms
Impedance: 8 ΩFrequency range: 100 Hz-18 kHzSensitivity: 83
db
To make drills, pay attention that does not exist water pipes or
electric wires.
We recommend use a cable POT type caliber 18 or 20
Before to use your new product, please read the manual.
