8/16/2019 Exhibit 38 PWHT Report
1/4
Heat Treatment Report
Job No. DE
Report No.
Page:
Heat Treatment Date Chart No.
INPEC Procedure No. Furnace/Local - PWHT Local-PWHT
Thermocouple S/N Recorder S/N
Parameters Required Actual
Holding Temp. (°C) 600-650 °C 630 °C
Holding Time (minutes) 60 min.up to 2"(1.5 min./1" over
2") 70 min.
Heating Rate (°C/hr) 220 °C max. 200 °C
Cooling Rate (°C/hr) 220 °C max. 200 °C
Other
S.No. Dwg. No. Spool / Item No. Remarks
1 INPEC-DEMO2012-U1 Rev.(0) Sheet 1/1
2
3
4
5
6
7
8
9
10
11
12
A sketch describes the placement of thermocouples must be
attached to this report.
Prepared By Approved By Accepted By
Name : Name : Name :
Title : Heat Treatment Operator Title : QC Inspector Title
: : QC Manager
Signature / Date : Signature / Date : Signature / Date
:
ASME Q. C. Manual Exhibit No. (38) Rev.: 0
Date:01/09/2012
S A M P L
E
