7/26/2019 F0102 Master Microphone
1/1
Follow these steps and click the corresponding movie to view the
procedure for
programming a Digital Audio Master Microphone for Single Channel
Operation
(Adobe Reader 9 or later is required to correctly viethis
document Click hereto download the free view
2011 Tyco Safety Products, All Rights Reserved.
F010
How to Program a DigitalAudio Master Microphone for
Single Channel Operation4100ES
International Trade Controls and Restrictions
This material may contain information or technology the export
or re-export of which is restricted by U.S. laws and regulations.
By viewing this material, the recipient agrees to the following:
(i) the recipient's use of
contents of this material shall comply with all applicable laws,
rules and regulations, including, without limitation, U.S.
international trade laws and regulations, and (ii) the recipient
may not transfer or otherwise expo
re-export any information or technology contained in this
material except in full compliance with the export controls
administered by the U.S. and other countries and any applicable
import and use restrictions.
To give us feedback, click he
1. Open the ES Programmer and click the Custom Control tab.
2. Right click the Programming Block where you will add the
Microphone Equation, and then click Add Equation
3. Type an equation label, such as Microphone Operation, click
Apply and then OK.
4. Click within the Equation Comment text box and document the
equation operation.
5. Click within the Equations text box and then click the Add
button.
6. Click Next twice and then type ON for an Input Qualifier.
7. Click Next, type P191 for a Point Name and then click
Finish.
8. Repeat this process for the Output Qualifier: type T for
Track Point with a Point Name of P131.
http://get.adobe.com/reader/mailto:[email protected]?subject=F0102%20Tutorial%20Feedbackmailto:[email protected]?subject=F0102%20Tutorial%20Feedbackhttp://get.adobe.com/reader/
