11
 BMS F30 Stage1 & JB4 Install Guide 1/2/2014 All use subject to terms and conditions posted at burgertuning.com/terms 1) Disconnect negative battery terminal in the trunk by removing the 10mm bolt. 2) Remove the plastic engine cover. The cover simply lifts off. Also remove the passenger side cowl cover which is secured by 3 10mm plastic release bolts. Turning the bolts 90 degrees each will release the tab and allow you to pull the cover off. 3) The JB4 harness is divided in to 4 "connectors" each with its own wire color. Rainbow, Brown, Purple, and Blue. In addition there are 4 "Stage2" wires next to the control box which are green, brown, red, and black. Note that for Stage1 you will be installing Rainbow and Brown only. For JB4 you will be installing all but purple & in some models blue is not used.

f30 Install

Embed Size (px)

Citation preview

8/11/2019 f30 Install

http://slidepdf.com/reader/full/f30-install 1/11

8/11/2019 f30 Install

http://slidepdf.com/reader/full/f30-install 2/11

8/11/2019 f30 Install

http://slidepdf.com/reader/full/f30-install 3/11

8/11/2019 f30 Install

http://slidepdf.com/reader/full/f30-install 4/11

8/11/2019 f30 Install

http://slidepdf.com/reader/full/f30-install 5/11

8/11/2019 f30 Install

http://slidepdf.com/reader/full/f30-install 6/11

8/11/2019 f30 Install

http://slidepdf.com/reader/full/f30-install 7/11

8/11/2019 f30 Install

http://slidepdf.com/reader/full/f30-install 8/11

8/11/2019 f30 Install

http://slidepdf.com/reader/full/f30-install 9/11

8/11/2019 f30 Install

http://slidepdf.com/reader/full/f30-install 10/11

8/11/2019 f30 Install

http://slidepdf.com/reader/full/f30-install 11/11