8/14/2019 Fabric Put-Up and Spreading Modes

1/10

Fabric Put-up and Spreading Modes

Fabric Put-up;Open and Rolled

Fabric is flat open with the face to the inside of the roll

Right click on the image and select "save image" to save to your local drive

8/14/2019 Fabric Put-Up and Spreading Modes

2/10

Fabric Put-up; Folded and Rolled

Fabric is folded on one end and both selvedges are

superimposed on the other edge of the roll

Face is to the inside of each folded layer

Right click on the image and select "save image" to save to your local drive

Fabric Put-up; Tubular Fabric Rolled

8/14/2019 Fabric Put-Up and Spreading Modes

3/10

8/14/2019 Fabric Put-Up and Spreading Modes

4/10

Spreading starts at one end of the table on each ply

Right click on the image and select "save image" to save to your local drive

Spreading Mode; Open Fabric, Face One Way, Nap UP and Down

(F/O/W, N/U/D)

8/14/2019 Fabric Put-Up and Spreading Modes

5/10

Spreading starts at one end of the table. Fabric is cut at the far end, rotated 180

degrees, then spread to the beginning. The Fabric is cut and rotated 180

degrees then the process is repeated.

Right click on the image and select "save image" to save to your local drive

Spreading Mode; Open Fabric, Face to Face, Nap One Way (F/F, N/O/W)

8/14/2019 Fabric Put-Up and Spreading Modes

6/10

Spreading starts at one end of the table. Fabric is cut at the far end, the roll is

brought to the beginning of the table, rotated 180 degrees, then spread to

the far end again. The Fabric is cut at the far end, brought back to the

beginning of the table, rotated 180 degrees then the process is repeated.

Right click on the image and select "save image" to save to your local drive

Spreading Mode; Open Fabric, Face to Face, Nap Up and Down (F/F,

N/U/D)

8/14/2019 Fabric Put-Up and Spreading Modes

7/10

Spreading starts at one end of the table. Fabric is folded over at the far end, then

spreading continues back to the beginning of the table. The Fabric is folded

over then the process is repeated.

Right click on the image and select "save image" to save to your local drive

Spreading Mode; Folded Fabric, Face to Face, Nap One Way (F/F,

N/O/W)

8/14/2019 Fabric Put-Up and Spreading Modes

8/10

8/14/2019 Fabric Put-Up and Spreading Modes

9/10

Spreading starts at one end of the table. Fabric is spread to the far end of the table.

The fabric is folded over, then spread back to the beginning. The fabric is

folded over, then the process is repeated. On the control side of the table the

Fold is superimposed one layer on the previous layer.

This process is also used on tubular rolled fabric

Right click on the image and select "save image" to save to your local drive

8/14/2019 Fabric Put-Up and Spreading Modes

10/10