FILEDSTRIPPING AN ELMA-WERKE KGP 68

1. Remove magazine and check that the chamber is empty.

2. Press on the rear of the gun and remove the locking bolt.

3. Pull the toggle back and expose and drift out the toggle pin.

4. Note the positions of the firing pin guide rod and the recoil spring and guide rod assembly, then remove them.

5. Remove the barrel/slide from the frame

6. Remove the firing pin. The components may now be cleaned and lubricated.

7. To reassemble, fit the firing pin, spring & guide rod, as well as the recoil

spring assembly, back into the gun.

8. Carefully align the toggle holes and the hole in the firing pin guide rod and

reinsert the toggle pin.

9. With the toggle closed, press on the rear of the slide/toggle assembly and

reinsert the correctly aligned locking bolt.