8/13/2019 Florence-cathedral i e a4

1/5

8/13/2019 Florence-cathedral i e a4

2/5

Each page of the "Parts sheet" has a sheet number in the top left-hand corner (Sheet No.2 No.10). Work in order of these sheet numbers.

Each part has a "parts number" printed on it.Also, each glue tab is marked with one of three symbols.indicates glue tabs to be attached to connection areas within the same part.

For glue tabs marked with a number, attach them to the glue tab with the same number on the connection areas of other parts. For glue tabs marked with a "parts number," attach them to the part with the number printed. Check the diagrams in the "Assembly Instructions" carefully for each part as you work.

Before starting.

The numbers in the Assembly Instructions indicate the order to attach parts.Follow this order when attaching.

For small parts,assemblywill be easier if you use aslightly thinner type of paper.

Handy Hint

Attach the red circled area of 2Bto the part of 2D indicatedby the arrow as shown.

* The raised up part of the roof peak

Sheet No.2

Sheet No.3

* Glue together the inside edgesof the seam to make the roof peak stand up.

8/13/2019 Florence-cathedral i e a4

3/5

For small parts,assembly will be easier if you usea slightly thinner type of paper.

Handy Hint

There are spares provided for the small parts,to use in case of misplaced parts or cutting errors.

Attach the cross so that itfaces the east-west direction.

Align the reverse sides and attach.

South

North

West

East

Mountain foldValley fold

Attach 25 and 26in the same way.

West face* Attach to the areas labeled 14,15,and 16 on part 8A of the display stand.( Refer to Assembly Instructions page 5)

Sheet No.4 Sheet No.5

Attach parts 4D 4K tothe areas of 4C as shown.

8/13/2019 Florence-cathedral i e a4

4/5

Sheet No.6, 7

Sheet No.8, 9, 10Sheet No.6

Sheet No.7

Sheet No.10

Sheet No.9

Sheet No.8

* After completing the display stand, attach the buildings to the areas shown.

8/13/2019 Florence-cathedral i e a4

5/5

Florence Cathedral, Italy : Assembly Instructions

Sheet No.9, 10

Sheet No.9

Sheet No.10

View of completed model

South

North

WestEast

entrance

Attachthefacewith theentrance(shown above)sothatit facestheeastdirection.

* Attach the short side flaps inside.

* Attach the four corners.

* Fold in the center,and glue the reverse sides.

* Attach the buildings to the completed display stand.

* Glue this side