Upload
redxus
View
19
Download
0
Embed Size (px)
Citation preview
European Aviation Safety Agency
Design Organisation Handbook template
Doc # document.docx
Issue 18/12/2013
Test Witness Report template
Log of issues
Issue Issue date Change description
001 18/12/2013 Initial issue
Test Witness ReportDoc.-No.
Revision
Date
EASA.21J.xyz Project Reference Page 2 of 4
Document title
Table of ContentTable of Content....................................................................................................1
1. Project..........................................................................................................2
1.1 Aircraft Type/Model...................................................................................2
1.2 Project no..................................................................................................2
2. Certification Specification.............................................................................2
3. Conformity Checks.......................................................................................2
3.1 Test Stand Conformity and Capability.......................................................2
3.2 Test Specimen Conformity........................................................................2
3.3 Pre-Test Inspection Check.........................................................................3
3.4 Specials to Test Equipment.......................................................................3
3.5 Instrumentation / Measurement System Calibration.................................3
4. Test Witnessing............................................................................................3
4.1 Test Sequence...........................................................................................3
4.2 On-Test Inspections...................................................................................3
4.3 Test Deviations.........................................................................................3
4.4 Malfunctions during test............................................................................3
4.5 Post-Test Inspection..................................................................................3
5. Conclusion....................................................................................................3
6. References...................................................................................................3
7. Definitions/Abbreviations/Acronyms.............................................................3
DO-07 (11/2013)
This “Test Witness Report” form is intended to be used as template to assist applicants in applying for DOA and therefore demonstrating the required design capability and provide a basis for the DOA applicant to produce the own Template for a Classification for Design Changes.
The template form and text already entered are examples and shall be checked if they are appropriate and be changed accordingly by the organisation. All text boxes should be deleted after the information is entered to produce the final DOA form.
The required information can be presented entirely in this document, or in additional documents appropriately identified and referred to.
Test Witness ReportDoc.-No.
Revision
Date
EASA.21J.xyz Project Reference Page 3 of 4
Name / Function Date Signature
Prepared
……………/……….
Checked/approved
…………../………..
1. Project
1.1 Aircraft Type/Model
1.2 Project no.
2. Certification Specification
3. Conformity Checks
3.1 Test Stand Conformity and Capability
3.2 Test Specimen Conformity
3.3 Pre-Test Inspection Check
DO-07 (11/2013)
List here the affected product type/model.
Reference the project no.
List or better write down the certification specification requirements where this document demonstrates compliance with.
Test Witness ReportDoc.-No.
Revision
Date
EASA.21J.xyz Project Reference Page 4 of 4
3.4 Specials to Test Equipment
3.5 Instrumentation / Measurement System Calibration
4. Test Witnessing
4.1 Test Sequence
4.2 On-Test Inspections
4.3 Test Deviations
4.4 Malfunctions during test
4.5 Post-Test Inspection
5. Conclusion
6. ReferencesRef. No.
Document No. Issue Title
7. Definitions/Abbreviations/Acronyms
DO-07 (11/2013)