ANTICORIT DFW

Corrosion Protection Oil and Dewatering Fluid

ANTICORIT DFW is a corrosion preventive and dewatering fluid which, when the solventevaporates, forms a soft, waxy-oily film. This offers excellent corrosion protection, intensive

dewatering properties, stability against dragged-in acids and alkalines along with beingextremely economical.

ANTICORIT DFW is recommended for the rapid drying and simultaneous protection ofmetal components and tools; after galvanizing and washing processes for the interim andlong-term protection of bare metal surfaces.

ANTICORIT DFW gives galvanized screws a consistent coefficient of friction. Even if thefastener is repeatedly retightened the torque variation remains minimal. The product allows

automatic screw and nut drivers with preset torques to work with the utmost of accuracyand reliability.

ANTICORIT DFW complies with the VW TL 52 111 and FORD SZ 600 A specificationsconcerning friction coefficients and additionally offers good corrosion protection.

Application:Normally by dipping but if such facilities are not available ANTICORIT DFW can be

sprayed. However, all precautions applicable to solvent-based products should beobserved. If necessary, please consult the corresponding Material Safety Data Sheet.If sealed in the original container, ANTICORIT DFW can be stored for min. 5 years at 5 -

40 C.

Characteristics:

Properties Unit Value Test method

Colour 5.0 ASTM D 1500

Flashpoint C 40 ASTM D 56

Density at 15 C kg/l 0.820 ASTM D 1258

Viscosity at 20 C mm/s 2.2 ASTM D 445

Film weight g/m 0.9 FLP-F 3 *)

Evaporation residue % 22 FLP-V 1 *)

Corrosion Protection Data (on RRSt. 1405 m test

panels)

Humidity cabinet hours 300 ASTM D 1748

Salt spray test hours 24 ASTM B 117

Condensation climate cycles 30 DIN 50 017

KFW

*) = FUCHS Laboratory procedure

Disclaimer of Liability

FUCHS PETROLUBE (M) SDN BHD http://www.fuchs.com.my/en/products/print.php?id=812

1 of 1 26.06.2014 10:54