Garage Band Tutorial in editing down music

Step 1:Open and choose a new project.

Step 2:Save/create

Step 3:Drag and drop your song into the timeline.

Step 4: Edit it down.- Press the edit button. - Th en proceed to the area of the start point of your song.o If there is there is music prior to this section click and drag to select the music that precedes the beginning of your selection.o If your selection is at the very beginning then you would do the same for the tail end.o If your selection is in the middle, you will need to cut the areas prior to and just aft er your selection.o Aft er each one of these steps if the music is not already at the beginning of the track then you should click and drag it to the beginning of the track.

Step 5:Fades.- You will fade in and out the beginning of your song so that there is not quite an abrupt start or ending to your music selection.o Adding a Fade in/out is relatively easy in garage band.o You click the arrow next to the left and right stereo mixing knob to open up the master volume.o There is already an initial point at the very beginning of your track, go about a half inch away from that point and click on the line making a new point.o After making the new point go back to the initial and drag it to the bottom. This how you create a fade in.o To make the a fade out you make to points to the end of your track and pull the latter down to the bottom.

Step 6:Exporting (Sharing).- Once you have the song the way you want it, then you will need to export it.o You do this by sharing…o Go to the Share drop down menu then click export song to disk.o You’ll be prompted on how to set up your export. • CompressUsing:MP3endcoder• Quality:HighQuality• HitExport.• Promptstosave.