Upload
others
View
3
Download
0
Embed Size (px)
Citation preview
MAN
UAL
LED-2100 - USER MANUAL
KEY FEATURES · Integrated Shoe Mount
Connects To DV & HDSLR Cameras
· Unit Has 25' Lighting Range & 65° Illumination Angle
· Stackable Mounting Feature Interlocks With Other Units
· Mounting Bracket Connects To 1/4 20 Camera Tripod Screw
POWERING LED LIGHT · Open latch found on battery compartment
cover by squeezing tab upwards; hold tabin upward position and remove the entire cover
· Install fully-charged battery by sliding it into battery compartment; ensure that gold-colored battery conductor contacts face upwards and are touching metalprongs in the battery mounting area
· Replace battery compartment cover
· Move the power switch into theON position to illuminate the LEDs
MOUNTING LED LIGHT ON CAMERA · Begin by positioning light unit directly
atop camera or video camera
· Ensure that locking ring is fully loosened and slide cold shoe mount into shoe of camera; rotate ring clockwise to lock light into place securely
MOUNTING LED LIGHT ON BRACKET · Included mounting bracket is designed for
point-and-shoot cameras that have no shoe mount; begin by mounting light on cold shoe found on bracket
· Insert 1/4 20 screw found on bracket into the 1/4 20 threading mount found on bottom of camera; adjust spacing of camera by sliding knob along length of bracket arm and secure tightly
INTERLOCKING WITH OTHER LED UNITS · Ensure that device locking ring is fully
loosened and slide cold shoe mounting into interlocking expansion slot of another compatible Genaray LED light unit; rotate ring clockwise to lock light in place securely
· Up to 3 compatible Genaray LED light units can be mounted to each individual light unit or in a stacked vertical format for increased illumination
· Do not attempt to disassemble, repair or perform any unauthorized modifications on device
· Do not handle with wet hands, immerse in liquids or expose to water and rain; electric shock or fire may result
· Device contains small parts which may pose a choking hazard; keep out reach of children
· Do not operate device in presence of flammable gas or vapors
· Do not use product if it emits smoke or a strange odor; disconnect power source immediately to avoid personal injury and contact place of purchase
· Observe caution when handling batteries; only use batteries approved by the manufacturer of this product
· Batteries are prone to leakage when fully discharged; to avoid damaging product be sure to remove batteries when leaving product unattended
· Do not intentionally stare or gaze at LED light panel for prolonged periods while device is on
· Do not use or leave device in conditions of extreme heat, severe cold or high humidity
· Unit will display a decrease in brightness when the battery runs low; be sure to replace battery when necessary to avoid affecting recording quality
· When cleaning the device, use only a mild detergent solution and quickly wipe dry with a soft cloth
· Please dispose of used batteries, packaging and old devices in accordance with appropriate environmental regulations
SAFE
TY W
ARNI
NGS
LED-2100USER MANUAL
INTRODUCTION
Thank you for choosing the Genaray LED-2100 On-Camera Light. This product will provide you with powerful, portable and dependable illumination that can be used in a variety of settings. Featuring advanced light dispersion capabilities and supporting accessories that add instant versatility to this light kit, the Genaray LED-2100 On-Camera Light proves to be the perfect choice for photographers and videographers alike.
PRODUCT CONTENTS1 - LED Light With Built-In
Diffuser & Shoe Mount
1 - Thread Adapter for Sony AIS Shoe Mount
1 - Included Camera Mounting Bracket
2 - 700mAh Li-Ion Rechargeable 1-Hour Batteries
1 - 110-240V AC/DC Wall Charger
1 - European Plug Adapter
LIMITED 1 YEAR WARRANTY
See website for detailswww.genaraylighting.com
Built-In Diffuser
LED Array
Locking Ring
Interlocking Expansion Slots
Cold Shoe Mount
Power Switch
1/4 20 Threaded Mount Battery
Compartment Cover
CUSTOMER SUPPORT
Please send email correspondence to:[email protected]