Use less. Spend less. Do more.

Sponsored by Nebraska Public Power District in partnership with its Wholesale Utility Customers.

E38

5A61

3

Commercial HVACIncentive Program

KEEP COOL & SAVE MONEY

For program guidelines and application,visit www.nppd.com or contact

Steve Zach (402-563-5472)sjzach@nppd.com

Get EnergyWiseSM TodayEnergyWiseSM programs offer incentives to homeowners,

businesses, and agriculture to help cover the cost of a variety of energy-efficient upgrades.

01/0

1/20

20

ELIGIBLE EQUIPMENT

There may be equipment available on the market that does not meet the Minimum Cooling and/or Heating Efficiencies listed above. Check with your contractor prior to purchase. Send completed and signed application to your local electric utility office.

* Provide documentation that shows manufacturer, model number and that states the equipment is “inverter driven”.** Any efficiency rating qualifies on water-to-air and water-to-water units

WLHP – Water Source Heat Pump (typically boiler/ccoling tower applications); GHP - Geothermal Heat Pump (open loop, earth, or pond coupled).

Table implies new matched indoor and outdoor components. If different, contact your electric utility.

Equipment efficiencies are full load ratings according to test procedures and conditions specified in ASHRAE Standard 90.1 – Energy Standard for Building Except Low-Rise Residential Buildings, and the following standards as applicable: AHRI/ISO 13256-1 – Water-to-Air and Brine-to-Air Heat Pumps, AHRI/ISO 13256-2 – Water-to-Water and Brine-to-Water Heat Pumps, and ANSI/AHRI Standard 1230 – Performance Rating of Variable Refrigerant Flow Multi-Split Air-Conditioning and Heat Pump Equipment. COP ratings are at 47°F.

Equipment Type(Split or Package)

MinimumCooling

Efficiency

MinimumHeating

Efficiency

IncentiveSize(tons)

The process is easy –just follow these simple steps1. Visit with your electric utility to discuss your project and pick up an

application form. An application form is also available on-line, which makes calculating incentives easy.

2. Select a contractor and install HVAC equipment that meets the criteria identified in the table to the right.

3. Complete an application form after the installation is complete and the terms and conditions are satisfied.

4. Submit the signed application (along with proof of purchase identified in the terms and conditions) to your local utility for the incentive within three months of the installation.

HVAC systems are the primary energy consumers in commercial buildings. Improving the performance of your HVAC system not only saves energy, but can have a positive impact on your building occupants´ health, comfort, and productivity as well.

Have an old air-conditioner, rooftop unit, or heat pump that should be replaced? Or are you building a brand new facility and considering a state-of-the-art HVAC system that will provide energy savings for years to come? Either way, our Commercial HVAC Incentive Program will pay you for doing so!

HVAC systems canaccount for half of abuilding’s energy usage

UnitCode

Qualifying systems include: Split or package air-conditioners (heat source can be electric or fossil fuel)

Split or package air source heat pumps (back-up fuel source can be either electric or fossil fuel)

Split system or package water-source heat pumps (typically boiler/cooling tower applications) or ground-source heat pumps (open or closed loop)

For equipment in table less than or equal to 20 tons, multiple units totaling > 20 tons installed under one project are allowed

Incentives valid as of 1-1-2020. Subject to change without notice. Verify current incentive amounts and program information at www.nppd.com. These EnergyWiseSM programs are only available to customers of NPPD and customers of its wholesale utilities.

$15/ton

$30/ton

$40/ton

$80/ton

$100/ton

$100/ton

$220/ton

n/a

*

*

**

*

8.5 HSPFor 3.3 COP

8.5 HSPFor 3.3 COP

*

*

**

*

15.0 SEERor 14 IEER

14.0 SEERor 12.2 IEER

15.0 SEERor 14 IEER

< 20

< 20

< 20

< 20

< 20

Any

Any

Air Conditioner

Air Conditioner - Variable Capacity

Air Source Heat Pump

Air Source Heat Pump

Air Source Heat Pump - Variable Capacity

Water Source Heat Pump

Geothermal Heat Pump (ground source oropen loop)

AC1

WLHP

AC2

AS1

AS2

AS3

GHP