Upload
hussein-badiyow
View
235
Download
0
Embed Size (px)
Citation preview
8/6/2019 GPRS Software Protocol
1/16
Gprs software or General Packet Radio Service is apacket switched technology, based on GSM. Theradio and network resources of gprs software are
only accessed when data actually needs to betransmitted between the gprs software mobile userand the gprs software network. This data is divided
into packets and is then transferred via the radioand core gprs software network.
8/6/2019 GPRS Software Protocol
2/16
Conty B etween alternating transmissions, no gprs software
network resources need to be allocated. gprs softwareoffers up to 115 kbps, depending on the networkavailability, channel coding scheme and terminalcapability. This increase in speed in gprs software withrespect to GSM is achieved by using more than onetimeslot of the TDMA frame. Due to the packet
switched characteristics of gprs software the allocationof the available timeslots may vary from one instant tothe next (e.g. it may have 8 timeslots at one time and 4later on).
8/6/2019 GPRS Software Protocol
3/16
y The General Packet Radio Service (GPRS) is a new value added service that allows information to be sent
and received across a mobile telephone network. Itsupplements today's Circuit wireless Switched Dataand Short Message Service.
8/6/2019 GPRS Software Protocol
4/16
y Timeslot building requires new functionality on themobile side. Gprs software needs a Serving gprs
software support node (SGSN), a Gateway gprssoftware support node (GGSN) and a charging gateway function to support packet switched transactions. Thepacket switched traffic is separated from the circuitswitched traffic at the B SC/PCU and diverted to thegprs software core network. To support point-to-multipoint features, a point-to-multipoint ServiceCenter (PTM-SC) needs also to be added.
8/6/2019 GPRS Software Protocol
5/16
y Depending on the environmental radio conditions,one of the four coding schemes (CS1, CS2, CS3, CS4)
can be selected. CS1 and CS2 offer good error detectionand correction with low throughput; in the first step of gprs software only these two techniques may be used.CS3 and CS4 provide higher throughputs but havelittle or no error correction capabilities.
8/6/2019 GPRS Software Protocol
6/16
y Table 1 shows the different data rates that can beachieved with the different coding techniques.
8/6/2019 GPRS Software Protocol
7/16
8/6/2019 GPRS Software Protocol
8/16
y B ecause gprs software is packet switched traffic, newprotocols and channel types are required. In gprs
software the mobile device is permanently attached tothe network, providing a virtual connection withoutcost and data transfer (GPRS-Attach). gprs software- Attach procedure is executed whenever a gprs softwareenabled mobile station is switched on and needs toinform the network about its presence.
8/6/2019 GPRS Software Protocol
9/16
y The two peers of a gprs software attach procedure arethe mobile station (MS) and the Serving gprs software
Support Node (SGSN). Depending on the availability of the packet Common
8/6/2019 GPRS Software Protocol
10/16
y Control Channel (PCCCH), the gprs software-Attachprocedure may be executed on Circuit Common
Control Channel (CCCCH).y Figure 1 shows the gprs software system architecture,
indicating new functionality required for phase2+operation.
8/6/2019 GPRS Software Protocol
11/16
8/6/2019 GPRS Software Protocol
12/16
y Configurations:y Layer 1. Radio gprs software. This layer includes the
following GSM phase2+ ETSI standards:y GSM 05.02 Access & Multiple Multiplexing.
GSM 05.03 Interleaving Code/Decoder Channel.GSM 05.04 Demodulator and Modulator.
GSM 05.05 Receiver and Transmitter.GSM 05.10 Synchronization.
8/6/2019 GPRS Software Protocol
13/16
y Layer 1.Vocoders gprs software. This layer includes thefollowing GSM phase2+ ETSI standards:
y
GSM 06.10 Full rate speech transcoding.GSM 06.20 Half rate speech transcoding.GSM 06.60 Enhanced Full rate speech transcoding.GSM 06.90 Adaptive multi-rate speech transcoding.
GSM 06.93 Discontinuous transmission for AdaptiveMulti-rate.
8/6/2019 GPRS Software Protocol
14/16
y Layer 2 & 3 GSM phase 2+ ETSI standards:y GSM 03.09 Hand-over.
GSM 03.22 Link control.GSM 04.04 PROTOCOLS Layer 1.GSM 04.05 PROTOCOLS Layer 2.GSM 04.06 PROTOCOLS Layer 2.
GSM 04.07 PROTOCOLS Layer 3.GSM 04.08 PROTOCOLS Layer 3.GSM 05.08 Power control.
8/6/2019 GPRS Software Protocol
15/16
y EGPRS (also call EDGE) is an enhanced version of gprssoftware, that uses a different modulation technique, 8
PSK, that has a spectral efficiency of 3 bits/s/Hz. gprssoftware uses GMSK, with a spectral efficiency of 1bit/s/Hz.
8/6/2019 GPRS Software Protocol
16/16
y GPRS Software will provide an important boost tomobile data usage, because of its flexible feature set,
its latency, efficiency and speed.y The following text, in the links below, provides VOCAL
datasheet as a source of background informationabout gprs software.