To measure total weight:Rest the club in the shaft cradle so that it lies perpendicular to the scale. Slide the weight until the beam levels up. Read the total weight in grams or ounces on either side of the scale.

To measure component weight: Place the desired component in the weighing tray and about center. Measure by sliding the weight until the scale levels up. Read weight in ounces or grams on either side of the scale.

Please note: The weighing tray should hang freely so it can swivel

unrestricted.

+/-0 Grams

level

-3 GramsBack tilt

+3 GramsForward

tilt

0Reading the Bubble for precision

Grip cap thickness

Pushhere

3) When placing a grip-less golf club on the weighing beam the shaft must butt against theshoulder of the grip cap so that the14” fulcrum can be referenced withthe added grip cap compensation.

The Clubmaker Swing Weight scale has a built-ingrip cap compensator and shaft holder that allowsfor the swing weighing of grip-less golf clubs.

The grip compensater is designed to suit golfgrips with caps no thicker than 1/4" (6mm). Pleasenote that when the grip cap compensator does notaffect swing weight in any way whether it is in theretracted or extended position.

Grip-less Golf Clubs

1) Push the grip capcompensator until itclips into position. This will prevent thegrip compensator frommoving when swingweighing golf clubs.

2) Place a golf grip on the weighing beam inside ofthe built-in grip gutter. The grip must butt against the grip back stop. You may want to place some 2-waytape on the back of the grip cap to prevent it fromslipping during the weighing process.

Please note thatthe grip shouldbe identicalto the grips thatare to be used for gripping the club or set of golf clubs.

The Clubmaker swing weight scale is a fine precision instrument designed for measuring the swing weight of golf clubs( 14" fulcrum) golf club total weight and individual component weight in both grams and ounces.

It has a host of built in features that enhances the speed and accuracy of any swing weighing job, such as a grip cap compensator for swing weighing grip-less golf clubs, precision bubble levels, and

We strongly recommend that you read this instruction manual so you can familiarize yourself with the scale and to take full advantages of its function and features. Thank you.

Golfsmith Inte rn ational, Inc 1 1 0 0 0 N ort h IH-35 Austin TX 7 8 7 5 31 -80 0 -45 6 3 3 4 4 www.golfsmith.com

TM

Auditor Clubmaker Swing Weight ScaleStock #240806

perfect balance assemblyof the levered parts.

3) Ensure the beam is free to swivel smoothly by leveling off the weighing beam by sliding the weight to the zero mark.

Operation:1) Unpack the swing weight scale and remove all bindings used to restrain the beam during shipping.

2) Place the scale on a work bench. Level the scale by winding up the leveling thumb screws until the bubble levels reads dead center.

Bubble Level

To measure swing-weight:Place the butt end of the grip against the grip back stop, the clubon top of the weighing beam as shown. Slide the weight along the scale until the beam levels up. The swing weight reading is taken at the mark on the sliding weight.