w w w . i n a t e c k . c o m

Instruction Manual

HBU3VL3-43 Port USB3.0 HUB +Gigabit Ethernet Converter

Inateck HBU3VL3-4 Manual

Introduction： Inateck HBU3VL3-4 is a 3 port USB 3.0 hub + gigabit ethernet converter. This new Universal USB 3.0 SuperSpeed 3-Port Hub and 10/100/000 Gigabit Ethernet LAN Network Adapter not only adds three USB 3.0 ports to your laptop or desktop, but also allows you to connect your device directly to your network via USB port. Use this Ethernet adapter to participate on multiple networks, replace damaged Ethernet ports, add a physical network connection to wireless-only systems, and replace network cards. This Ethernet adapter is not intended for use in connecting USB devices like a printer to a network.

Function Chart：

- 1 -

RJ45USB3.0 x 3

Features：● Super speed(5Gbps)/high-speed(480Mbps)/ full-speed(12Mbps)● Good function of Gigabit network upon super speed USB3.0 port● Support IPv4/IPv6 network, full duplex, automatic flip and flow control● Support Power management, remote wake-up function and Gigabit network power automatic adjustment● Compliant with USB2.0 and lower version● Compliant with large capacity hard disk

System Requirements：Windows XP/Vista/7/8/8.1 (32/64 bit), Mac OS

Package Contents：● 1 x 3 Port USB3.0 HUB + Gigabit Ethernet Converter● 1 x Driver CD● 1 x User Manual

Hardware Installation：1. Connect HBU3VL3-4 with your computer, a “Found New Hardware” message will pop up and automatically finish installing. 2. Open “Control Panel” - “Network connection” to find a new “local connection” icon.3. Insert the network cable to the RJ45 port. If your

- 2 -

network has opened DHCP, you can obtain an IP address automatically, and then the network could be connected.4. If you need to set a static IP address, double click the new added “local connection” icon and find “Local network connection properties”. Double- click “Internet protocol (TCP /IP)” to set for it. The IP information should be obtained from the network administrator.

Driver Installation：No need of driver for USB 3.0 Hub. The driver is only for Gigabit Ethernet Adapter.

Please make sure the hardware is installed before installing the driver.If you cannot read the contents of the disk, please go to the following address to download the driver according to the product model: http://www.inateck.com/support

1. Insert the provided CD into your disk drive.2. Run the “Autorun.exe”, click the "Drivers", and select the appropriate driver version.

- 3 -

3. Then follow the instructions to finish installation.

Website: Http://www.inateck.comEmail: support@inateck.com

(Service time: Mon.-Fri. 9:00 - 17:00 CET)Tel: 0341-5199 8407