Upload
arline-hicks
View
217
Download
2
Embed Size (px)
Citation preview
Head Unit
THREE.2EQ/XOVER
RCA AMP4 Channels
SUBWOOFERAMP
4” 4” 6 x 9 6 x 9
RCA CABLES L/R
RCA CABLES for all speakers
RCA CABLES L/R
SUB BOX8” 8”
Use shielded RCA cables
Use shielded speaker cable
14GA14GA
12GA
Approx size of sub box will be 5” tall, by 10” deep, by 38” wide with subs pointing upwards, and the box placed directly behind back seats and in front of the shock towers
Also, I will be wiring the two subs in parallel which will give 2 ohms at the amp and 500 watts of power
I will disable (set to FULL) the crossover on the sub amp
CH1/2 - Leave XOVER off for 6 x 9’s (set to full on the switch)CH3/4 – SET XOVER to HPF, dial set between 150 and 180 hz
Xover above 80hz via 3.2 for 6x 9’s x 4’s
160hz via from RCA amp for 4”
Xover below 80hz via from 3.2 for subs
it also seems to me that we will be leaving the xover on the digital audio amp to be off. Because we have already told the audio data to stop at 80hz...YES, this is how it is.
Head UnitTHREE.2
EQ/XOVER
RCA AMP SUBWOOFERAMP
4 GA 4 GA
chassis ground lug nut
Ground Dist Block
4 GA
16 GA
16 GARelay
8 GA
I believe both the THREE.2 and the Head unit already have pre-wired 16 GA grounding and power wires on them that I cannot change since they are directly connected to the units themselves
Will need ring terminals and/or spade terminals for making some of the connections, and the grounds on the amps will be wired directly into the screw-down connectors on the amps
Relay
Head UnitBlue wire Remote turn on (no fuse needed)
15A fuse From the ‘low’ power dist block
To the ground dist block
Relay output power/signal
I would like to use a connector like this one shown here for the relay, but I don’t know if it will have four outputs on it or not. To feed all four of the devices that need a remote turn on signal. If not I need to make my own. Or just splice in a few power remote turn on wires to the outputs of this connector
antenna
Amp 2
THREE.2
Amp 1
5A fuse5A fuse
5A fuse
5A fuse
8GA
8GA
16GA
16GA16GA
16GA
Optima Redtop Battery
High Power Dist Block
Low Power Dist Block
2 GA
8 GA
10A fuse
80A ANL fuse
2 GA
Head UnitRed wire 10A fuse / 16 GA wireto ignition
10A inline fuse / 16GA wire, (always on power)
THREE.210A fuse
10A fuse
5A fuse
15A inline fuse / 8GA wire Relay15A fuse
5A inline fuse / 16GA wire
50A inline fuse / 4GA wire
SUB AMP
RCA AMP40A inline fuse / 4GA wire
50A fuse
40A fuse
8 GA
This is what the speaker cable will be from liberty cable
This is what the shielded rca cable I will be using from parts-express.com