HFL100EX Explosion proof LED helideck floodlight Orga BV Strickledeweg 13 3125 AT SCHIEDAM The Netherlands P.O. Box 3046 3101 EA SCHIEDAM The Netherlands T +31 (0)10 208 5555 F +31 (0)10 437 8445 [email protected] www.orga.nl All values mentioned in this document are typical values Document can be subject to modifications, without prior notice. Datasheet no.: HFL100EX rev 8 Explosion proof LED helideck floodlight to provide illumination of the landing area of the helideck. Key features • Reliable LED floodlight gives low cost of ownership and maintenance • Low power consumption due to highly efficient LED light source and lens system • Certified for Zone 1 areas with gas explosion hazard • Low profile design (<250 mm) allows direct mounting on helideck • Offshore resistant, high quality coating on cast light alloy base • Stainless steel mounting facilities to prevent corrosion problems, and integrated junction box • Wide beam spread for optimum equal helideck illumination • Easy aiming facility to meet requirement of computer simulation for helideck illumination Standards/Certification • Complies with ICAO Annex 14, Volume ll; International standards and recommended practices: Aerodromes, July 2013, chapter 5, paragraph 5.3.9 – Helideck Floodlights • Complies with Normam 27; Chapter 5; Section 0505d • Complies with Norsok C-004; Section 18.3 • SIRA 17ATEX0005 X; ATEX II 2 G Ex db eb op is IIB T4 • EN 60079-0, EN 60079-1, EN 60079-7, EN 60079-28 • IECEx KIWA 17.0003X; Ex db eb op is IIB T4 Gb • IEC 60079-0, IEC 60079-1, IEC 60079-7, IEC 60079-28 • Inmetro NCC 18.0033X; Ex db eb op is IIB T4 Gb IP64 • ABNT NBR IEC 60079-0, ABNT NBR IEC 60079-1, ABNT NBR IEC 60079-7 and ABNT NBR IEC 60079-28 Performance characteristics • Highly efficient LED light source and lens system • No glare • Aiming facilities provided Electrical characteristics • Operating voltage: see table • Power consumption: See table • Connection details: max. 4 mm²; 2 x M25x1,5 cable gland entries • Earth connection: internal max. 4 mm² and external M5 Physical characteristics • Dimensions (L x W x H): 250 x 480 x 215 mm • Weight: max 20Kg • Design degree of protection: IP66 • Operating temperature range: -50°C to +55°C System design, control and monitoring • When used in a floodlight system the average horizontal illuminance of the floodlighting will meet the regulatory requirements of at least 10 lux, with a uniformity ratio (average to minimum) of not more than 8:1 measured on the surface of the TLOF.

HFL100EX - orga.nl · • ABNT NBR IEC 60079-0, ABNT NBR IEC 60079-1, ABNT NBR IEC 60079-7 and ABNT NBR IEC 60079-28 Performance characteristics • Highly efficient LED light source

Download PDF Report

Upload
vuduong
View
365
Download
4

Embed Size (px)

Citation preview

Page 1: HFL100EX - orga.nl · • ABNT NBR IEC 60079-0, ABNT NBR IEC 60079-1, ABNT NBR IEC 60079-7 and ABNT NBR IEC 60079-28 Performance characteristics • Highly efficient LED light source

HFL100EXExplosion proof LED helideck floodlight

Orga BVStrickledeweg 133125 AT SCHIEDAMThe Netherlands

P.O. Box 30463101 EA SCHIEDAMThe Netherlands

T +31 (0)10 208 5555F +31 (0)10 437 [email protected]

All values mentioned in this document are typical values

Document can be subject to modifications, without prior notice. Datasheet no.: HFL100EX rev 8

Explosion proof LED helideck floodlight to provide illumination of the landing area of thehelideck.

Key features• Reliable LED floodlight gives

low cost of ownership andmaintenance

• Low power consumption due tohighly efficient LED lightsource and lens system

• Certified for Zone 1 areas withgas explosion hazard

• Low profile design (<250 mm)allows direct mounting onhelideck

• Offshore resistant, high qualitycoating on cast light alloy base

• Stainless steel mountingfacilities to prevent corrosionproblems, and integratedjunction box

• Wide beam spread for optimumequal helideck illumination

• Easy aiming facility to meetrequirement of computersimulation for helideckillumination

Standards/Certification• Complies with ICAO Annex 14,

Volume ll; Internationalstandards and recommendedpractices: Aerodromes, July2013, chapter 5, paragraph 5.3.9– Helideck Floodlights

• Complies with Normam 27; Chapter5; Section 0505d

• Complies with Norsok C-004;Section 18.3

• SIRA 17ATEX0005 X; ATEX II 2 GEx db eb op is IIB T4

• EN 60079-0, EN 60079-1, EN60079-7, EN 60079-28

• IECEx KIWA 17.0003X; Ex db eb opis IIB T4 Gb

• IEC 60079-0, IEC 60079-1, IEC60079-7, IEC 60079-28

• Inmetro NCC 18.0033X; Ex db ebop is IIB T4 Gb IP64

• ABNT NBR IEC 60079-0, ABNT NBRIEC 60079-1, ABNT NBR IEC60079-7 and ABNT NBR IEC60079-28

Performance characteristics• Highly efficient LED light

source and lens system• No glare• Aiming facilities provided

Electrical characteristics• Operating voltage: see table• Power consumption: See table• Connection details: max. 4 mm²;

2 x M25x1,5 cable gland entries• Earth connection: internal max.

4 mm² and external M5

Physical characteristics• Dimensions (L x W x H):

250 x 480 x 215 mm• Weight: max 20Kg • Design degree of protection:

IP66• Operating temperature range:

-50°C to +55°C

System design, control andmonitoring• When used in a floodlight system

the average horizontalilluminance of the floodlightingwill meet the regulatoryrequirements of at least 10 lux,with a uniformity ratio (averageto minimum) of not more than 8:1measured on the surface of theTLOF.