Remove the 4 upper tie-down hooks. Keep the 8 Torx bolts, but do not reuse the tie-down hooks.

I t e m N o . 3 1 8 3 0 0 0 4 - 3 0 - 1 6 1 0 DD5400 S. State RoadAnn Arbor, MI 48108

Truck Hero, Inc., 2016 Printed in U.S.A.

2017 Honda Ridgeline Mounting Rails

INSTALLATION INSTRUCTIONS

T50 Torx driver7/16” Wrench

Tools Required:

Front, upper tie-down hooks.Both sides.

Rear, upper tie-down hooks.Both sides.

Universal Kit # S21001010. Align the parts for assembly as shown.

truck-hero.com

3 1 8 3 0 0 0 4 - 3 0

Rear (tailgate)Bracket Right,

(Notch is at thetailgate end)

Rear (tailgate) Bracket Left

Mounting Rail Left (driver)

Mounting Rail Right (passenger)

Screws, 1/4-20 x 3/4LG S.H.C.S

Rail Bracket

Front (cab) Bracket(notice the slotted holes are on the top)

Tap Plate

IMPORTANT- INSTALL THESE RAILS FIRST

Slide two of the rail brackets into each rail. Align with the rail interior prole as shown.

Truck Hero, Inc., 5400 S. State Road, Ann Arbor, MI 48108 Visit us at truck-hero.com

Slide one rail bracket to the front, leavingthe other at the tailgate end of the rail.

(Notch is at thetailgate end)

With the rail brackets slid into the rails, assemble the brackets as shown. Loosely tighten the screws.

Mounting Rail Left (driver)Rail front, copied on left (driver) and right (passenger)

Tap Plate

Tap PlateRail Bracket

Rail Bracket

ScrewsScrews

Front (cab) bracket(notice the slotted holes are on the top)

Rear (tailgate) Bracket Left Rear (tailgate) Bracket Right

Mounting Rail Right (passenger)

Tap Plate

With the brackets mounted to the rails, place the rails on the truck. Position the rail so the front cap pad rmly contacts the bulkhead. Align the brackets so that they line up with the factory tie-down hook bolt holes, then thread in the factory bolts and tighten.

Tighten the front hardware while pushing down on the rail to make good seal contact with the truck bed at the same time also pushing the rail forward to keep good contact between the cap pad and bulkhead.Continue to push down on the rail while tighteningthe rear bracket hardware.

Cap padto bulkhead

Tighten both Torx bolts,then tighten bothAllen head bolts.Tighten both Torx bolts,

then tighten both Allenhead bolts.

A

B

Push downPush down

1

12

2

REFER TO TRUCK BED COVER INSTALLATION SHEET FOR NEXT STEPS