HotEx Billing Manager Installation Guide - Hotspot …hotspotexpress.in/docs/hotEx-RADIUS-Manager/hotEx-RADIUS... · Web viewBefore you install hotEx RADIUS Manager, you must properly

hotEx RADIUS ManagerhotEx RADIUS Manager

Installation Guide

2008-2009 Hotspot Express.

All rights reserved.

No part of this work may be reproduced, stored in a retrieval system, adopted or transmitted in any form

or by any means: electronic, mechanical, photographic, graphic, optic recording or otherwise, translated

in other language or computer language, without the prior written permission of Hotspot Express.

Due care has been taken to make this Installation Guide and accompanying software package as

accurate as possible. However Hotspot Express makes no representation or warranties with respect to

the contents hereof and shall not be responsible for any loss or damage caused to the user by the direct

or indirect use of this Installation Guide and accompanying Software System.

Hotspot Express reserves the rights to alter, modify or otherwise change in any manner, the contents

hereof, without obligation of Hotspot Express limited to notify any person of such revision or changes.

Mention of third-party companies and products is for informational purposes only and does not constitute

an endorsement. Hotspot Express assumes no responsibility with regard to the selection, performance, or

use of these products. All understandings, agreements or warranties, if any, take place directly between

the vendor and prospective users.

Registered Office: No.5, PK Lane, North Andar Street, Trichy 620002, TN, INDIA Phone: 91-431-2702310

Registered Office: #5, PK Lane, North Andar Street, Trichy 620002. TN, INDIA. Ph: 91-431-2702310, 91-431-3201958

Table of Contents

Hotspot Express Installation Guide 2

About this guide 4Intended Audience.......................................................................................................................... 5

Purpose of this Guide..................................................................................................................... 5

Typographical Conventions.............................................................................................................5

Typeface......................................................................................................................................... 5

Meaning.......................................................................................................................................... 5

Customer Support........................................................................................................................... 5

Installation (RADIUS Manager) 6

System Requirements................................................................................6Hardware requirement.................................................................................................................... 6

Software requirement...................................................................................................................... 6

Network Setup............................................................................................7Installing hotEx RADIUS Manager............................................................8Assign IP Address....................................................................................18To check the Internet connectivity.........................................................22

Installation (hotspot client gateway) 27

System Requirements..............................................................................27Hardware requirement.................................................................................................................. 27

Software requirement.................................................................................................................... 27

Network Setup..........................................................................................28Installing hotspot client gateway............................................................29

hotEx RADIUS Manager Installation Guide 3

About this guide

About this guide

This section includes the following topics:

Intended Audience

Purpose of this Guide

Typographical Conventions

Customer Support


About this guide

Intended Audience

This guide is intended as an installation manual for the administrators, the agents and the clients on how to install the hotEx RADIUS Manager application.

Purpose of this Guide

This guide describes the step-by-step installation process of the hotEx RADIUS Manager application.

Typographical Conventions

Before starting, it is important to understand the typographical conventions used in this guide.

TABLE 1: TYPOGRAPHICAL CONVENTIONS

Typeface Meaning

Bold Menu items, input fields, radio button names, check boxes, drop-down lists, tab

names, buttons on the screen.

CAPS Keys on the keyboard.

“Quotes” Messages displayed on the screen.

Note: A note that calls attention to a topic with related information.

Warning: An Important message not to be ignored.

Customer Support

If you have problems, questions, comments or suggestions regarding HOTSPOT application and the documentation, contact us by e-mail at [email protected]. You can also call our customer support centre at (+91) 9362055005.

hotEX RADIUS Manager – Installation Guide 5

mailto:[email protected]

Installation (RADIUS Manager)

Before you install hotEx RADIUS Manager, you must properly check the system requirements.

System Requirements

Hardware requirement

Linux Cent OS compatible Pentium 4 or equivalent

2GB RAM (recommended)

Ethernet Card

40GB Hard Disk (minimum requirement)

CD-Drive

Preferably a Public Static IP

Software requirement

hotEx RADIUS Manager Installation CD

The hotEx RADIUS Manager Installation CD will format the hard disk and install necessary Operating System and modules. You need to dedicate this as a hotspot server and you cannot use this for any other purpose. You do not need any external third party software or Operating System during installation. It is preferred that you allocate a Public Static IP to be assigned to this hotspot server.

Network Setup

The following diagram illustrates the network setup for the hotEx RADIUS Manager.


Chapter 1

HOTSPOT EXPRESS

The hotEx RADIUS Manager server is connected to the Internet. All the wired and WiFi clients, from all the hotspot locations will be authenticated by this server.


HOTSPOT EXPRESS

Installing hotEx RADIUS Manager

Insert the hotEx RADIUS Manager Installation CD and configure as shown below. We will call this server as ‘hotspot server’ for convenience throughout this guide.

To start the installation

1. Insert the hotEx RADIUS Manager Installation CD. You will see the Welcome to hotEx RADIUS Manager Software Installation screen as below. Press ENTER to continue the

installation. You will see the screens as below.

2. To initialise the new partitions, click yes.

hotEX RADIUS Manager – Installation Guide

Warning:

The installation CD will completely format your hard disk. You will lose all

data in the hard disk. Please backup the hard disk before use, if

necessary. Please also ensure that this hard disk is having only one

partition.

8

HOTSPOT EXPRESS

3. Select the appropriate ‘Time Zone’ and click OK.


HOTSPOT EXPRESS


HOTSPOT EXPRESS


HOTSPOT EXPRESS


HOTSPOT EXPRESS


HOTSPOT EXPRESS


HOTSPOT EXPRESS


HOTSPOT EXPRESS

4. After the installation, the server will reboot and you will see the welcome screen as below.

Please ignore the login prompt because it is not necessary for you.

5. Connect a Laptop/PC in the same network attached to the hotspot server. The default IP

Number of the server is 192.168.1.55 (subnet 255.255.255.0). Set the IP of this Laptop/PC in

the same network (eg. 192.168.1.100/255.255.255.0). Please try http://192.168.1.55/admin in

the browser. You will be prompted to enter ‘Username and Password’.

Enter the User name (default is admin) and Password (default is admin) and click Ok.


http://192.168.1.55/admin

HOTSPOT EXPRESS

Typical Network Diagram illustrating

how to connect an Administrator PC/Laptop to setup hotEx RADIUS Manager


HOTSPOT EXPRESS

6. You will now see the web admin control panel of hotEx RADIUS Manager.

Assign IP Address

The default IP number assigned to the hotspot server is 192.168.1.55. You can change this IP Number as below.

1. Goto the Main Screen. Clicking on the left top Home button will bring you to the Main-Screen

always. Get into the screen as below. Home -> Miscellaneous -> IP Setting -> WAN IP Setting -> Assign Static IP for WAN Interface.


HOTSPOT EXPRESS

2. Enter your required IP Number and Click Update.


HOTSPOT EXPRESS

Note:Use WAN IP Address, when you configure Hotspot Client Gateway

3. The new IP number will be effective only after rebooting. To reboot, click ‘Reboot’.


HOTSPOT EXPRESS

4. Please wait until it reboots and you see the login screen.


HOTSPOT EXPRESS

To check the Internet connectivity

1. Goto the Main Screen selects the menu Miscellaneous -> Internet Connectivity. You will

see the menu Test Internet Connectivity. You may enter any valid Internet domain name or

IP Address (eg. Yahoo.com) and click PING.


HOTSPOT EXPRESS

2. You will get the SUCCESSFUL PING RESULTS, if the hotspot server is connected to

Internet.


HOTSPOT EXPRESS

3. Goto HOME, select the menu Miscellaneous -> NAS. You will see the “Add NAS” screen.

NAS is an acronym for Network Access Server (in our case, it is the LinkSys router in each

hotspot location). Enter the Domain Name or IP Number and Secret, of the ‘hotspot location’

and click Add.


HOTSPOT EXPRESS

Note:If the ‘hotspot location’ does not have a Public Static IP number or domain name, you may enter “ 0.0.0.0/0 ”.

4. NAS Location is added.


HOTSPOT EXPRESS

5. Goto HOME, click Shutdown -> Reboot to effect the changes.


HOTSPOT EXPRESS

Installation (hotspot client gateway)

Before you install hotspot client gateway, please check for the below system requirements.

System Requirements

Hardware requirement

LinkSys WiFi Router (Model WRT54GL)

Laptop/PC (for initial Setup only)

Software requirement

Openwrt Firmware

RADIUS Client Configuration File

You are going to connect LinkSys Router with the Laptop/PC through WiFi. No other software or

Operating System is necessary.


Note:

Please download the Openwrt firmware from

http://hotspotexpress.in/ispot/openwrt-wrt54g-squashfs.bin

And RADIUS Client configurations file from http://hotspotexpress.in/ispot/config.tgz and save them in your desktop.

27

http://hotspotexpress.in/config.tgz

http://hotspotexpress.in/openwrt-wrt54g-squashfs.bin

HOTSPOT EXPRESS

Network Setup

Typical Network Diagram illustrating Hotspot Client Gateway


HOTSPOT EXPRESS

Installing hotspot client gateway

You are now going to convert LinkSys router as a hotspot client gateway, using the

Laptop/PC.

Switch on the LinkSys router.

Ensure the WiFi network adapter of the Laptop/PC is enabled and working, and set it in

DHCP Mode (i.e., ‘Obtain IP Address Automatically) as shown below.

1. After Setup the LinkSys, Open the browser (eg: Internet Explorer) and enter the ip

“192.168.1.1”. You will see the login prompt. Type the User name and Password (default

password is admin) and Click Ok.

2. You will see the Setup screen as below.


HOTSPOT EXPRESS

3. To upgrade the firmware, Please use the menu, ‘Administration Firmware Upgrade’

and get the screen as below.


HOTSPOT EXPRESS

4. Click browse, select the file (dd-wrt.v23_wrt54g) which you have already download, from

http://hotspotexpress.in/ispot/ openwrt-wrt54g-squashfs.bin.


http://hotspotexpress.in/

HOTSPOT EXPRESS

5. Click Upgrade and ensure that there is NO INTERRUPTION DURING UPGRADE. Please do NOT turn off the power or press the reset button during upgradation. Otherwise,

the LinkSys may go corrupted.

6. After 3-4 minutes, you will see the message “Upgrade Successfully”. (It is very important

to wait for this message. Do not go further until you see this message), Click Continue.

7. Open the browser and tries “192.168.1.1”. You will see DD-WRT control panel page.

Click the menu-tab on the page; you will see the login prompt page.


HOTSPOT EXPRESS

8. After login, you will see as below.

9. Click Base Setup, you will see as below.


HOTSPOT EXPRESS

10. Go to Administration Backup.


HOTSPOT EXPRESS

11. Choose the file (filename: RADIUS Client Config file), which was already downloaded from

http://hotspotexpress.in/ispot/config.tgz.

12. Click Restore.


http://hotspotexpress.in/ispot/config.tgz

HOTSPOT EXPRESS

13. You will see as below.

Note:1. The Primary RADIUS Server IP must be the same with the

menu of “hotEx RADIUS Manager -> HOME->IP Setting ->

WAN Interface Static ip settings -> WAN IP ADDRESS”


Enter your hotEx RADIUS Manager Server IP address. Preferably, this would be a Public Static IP

Enter the DNS Server IP Address of the ISP of the client hotspot location

36

HOTSPOT EXPRESS

2. The shared key highlighted in this screen, must be the

same, with the menu of "hotEx RADIUS Manager -> HOME ->

ADD NAS -> NAS Client Location -> SECRET"

14. Open the browser and try to access a webpage (eg. google.com). You will see the hotspot

server welcome page.

15. Click Login, you will see as below.


http://www.google.com/

HOTSPOT EXPRESS

16. Enter username and password, Click Login.

17. You will see the message “Logged in successfully” and see the timer window.


HOTSPOT EXPRESS

18. Now, you are logged in successfully and you can start using Internet.

19. To logout, please enter “ http://exit ” or “ http://logout ” in the browser.


http://logout/

http://exit/

HOTSPOT EXPRESS

------------- o o o ------------


Documents

HotEx Billing Manager Installation Guide - Hotspot …hotspotexpress.in/docs/hotEx-RADIUS-Manager/hotEx-RADIUS... · Web viewBefore you install hotEx RADIUS Manager, you must properly