How to Check for Proper Wheel Fitment

   

 

Print the wheel clearance diagram linked in the product page. Once printed, measure to make sure the print was to scale. If the print is not to scale, adjust the view size and print again. Cut out the measuring tool.  

 

All measurements are taken from the back side of the hub, with the wheel off. Use the center point of the wheel to measure. Place the bottom of the cutout at the center point of the wheel.  

 

Dimensions listed are for a brake system. Brembo recommends a minimum of 3mm clearance between the caliper and the wheel spoke or rim. In this picture, the customer did not have enough room between the face of the caliper and the spoke of the wheel.