Upload
swift-canoe-and-kayak
View
26
Download
0
Embed Size (px)
DESCRIPTION
This quick walk-through will show you how to install the fins on your new stand-up paddleboard!
Citation preview
SUP Fin Installation Outdoor CentreOutdoor CentreOutdoor Centre
Your SUP will come with a large main n, and in some cases, two smaller thruster ns. This will walk you through the quick and easy process of installing the ns. Should you need further clarication you can watch
the video on the SUP Love page of the Swift Outdoor Centre website at swifttouside.com
Start by taking the screw and square washer o the n provided. Some screws
require a screwdriver or allen key, others tighten by hand depending on manufacturer.
With the curve of the n toward the back of the board, insert the end with the nubs into the centre of the n
box so it slides along the track and slide it to toward the back of the board.
Slide the washer down into the slot inthe centre of n box so it slides along
the track running lengthwise inside the n box.
Slide the washer toward the bow so it is at the top of the nbox and remove the screw.
Push the spine of the n into the nbox and centre the n in the box.
Slide the washer down the n boxso it lines up underneath the hole in the n (you will need to use a pencil or other
thin object to do this) and insert the screw into the n and through the washer
below, then tighten.
1 2 3
The thruster ns go into the smaller ttings on either side of the main n. Some boards come standard with these ns - they are an add on for others.
With the n curl toward the back of the board, press the n into the small n boxes on either side of the main n.
Once the ns are set in simply tighten the screws to hold them in place.
Use the key provided to loosen o the small screws on the side of the openings for the ns so they are not poking into
the n boxes.
2
654
1